1) angular scan rate
角扫描(速)率
2) gular scanning rate
扫描角速率
3) scan rate
扫描速率
1.
Effect of scan rate on nonafriction properties of monolayer molecular deposition film on silicon;
扫描速率对硅表面分子沉积膜纳米摩擦特性的影响
2.
In addition,the effect of scan rate on peak current and potential was studied when a film CuX was formed,and the mechanism of dissolution o.
通过比较Cu在卤离子溶液与含 (NH2 ) 2 CS卤离子溶液中的电化学行为 ,解释了 (NH2 ) 2 CS的缓蚀机制 ;并研究了扫描速率对形成CuX膜的峰电位和峰电流的影响 ,探讨了Cu的阳极溶解机
4) scanning rate
扫描速率
1.
The performance test of MOD300 distributed control system is described in this paper and an analysis on the test results of 3 primary performance indexes——system response time, scanning rate and CPU load rate——was carried out.
本文介绍了北仑电厂1号机MOD300分散控制系统性能测试的情况,并对三个主要性能指标:响应时间、扫描速率和CPU负荷率的测试结果作了分析,对如何提高系统响应速度、降低CPU负荷率提出了建议。
2.
It was focused on design of the optimization about the parameters on the selective laser sintering processing,such as scanning rate,power of sintering and preheated temperature.
对ABS粉末塑料的选区激光烧结过程的成型工艺参数进行了优化设计,对其中影响最大的参数(扫描速率、激光功率、预热温度)的匹配以及成型参数的选择进行了优化设计,得出一组最佳组合的工艺参数。
5) Scanning speed
扫描速率
1.
Spheroidization of 316L stainless steel powder during laser sintering was investigated,regular phenomena in this test was studied,and the effects of processing parameters such as laser power,scanning speed were discussed.
此次采用球化效应较为明显的316L不锈钢粉末进行烧结实验,分析了球化效应产生的原因,对实验中产生的规律性现象进行了解释,并着重讨论了工艺参数中的扫描速率对表面球化的影响。
6) scan angular scope
扫描角速度
1.
First, the geometry of the scan mode is depicted, and the scan angular velocity and scan angular scope are determined according to the desired imagery patch size and cross-range resolution respectively.
首先描述天线波束扫描的几何关系,推导出为达到要求的成像分辨率以及成像区方位宽度所需的天线波束扫描角速度和扫描角度的计算公式。
补充资料：具有原子级分辨率的扫描隧道显微镜
具有原子级分辨率的扫描隧道显微镜
蜜些 坦有原了级分辨率的扫描隧道显微偏
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条