1) miscibility gap
混合间隙
2) miscibility gap
混溶间隙
3) mesh clearance
啮合间隙
1.
The author studies the academic curve and mesh clearance of powder metallurgy inner/outer rotor,then developes the pressing forming mould,sizing mould and production technology.
通过摆线型机油泵转子分析,依据粉末冶金内外转子的理论曲线反啮合间隙的形成规律,提出模具齿形曲线形成的方法和转子的生产工艺。
4) reasonable clearance
合理间隙
1.
This article introduces three reasonable clearances of turn sun with settke sun and move round carry with machine hult and the dint bearings with hull of axid fans,and the valid path of realized these reasonable clearances.
介绍了轴流式通风机转子与定子之间的间隙 ,动轮轮毂端面与机壳之间的轴向间隙 ,推力轴承与轴承座后盖的间隙及 3种主要间隙的合理值 ,并介绍实现这些合理间隙的有效途
5) Clearance fit
间隙配合
6) tolerance clearance
配合间隙
1.
This paper introduced the tolerance clearance for sleeve jointing tubes with an inorganic and three organic bonding agents.
以钢铁试样为模拟试样研究了大直径钢铁试样与陶瓷试样套接的适用胶粘剂和配合间隙。
补充资料：闭锁间隙
闭锁间隙----又叫弹低间隙。武器闭锁后，当枪机与机匣上的闭锁支撑面紧贴，枪弹以斜肩或底沿与枪管紧贴时，枪弹底面与枪机弹底窝平面之间的距离称为弹底间隙。若枪弹底平面与枪机弹底窝平面紧贴，则枪机匣上的闭锁支撑面之间的距离称为闭锁间隙。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条