1) hole flanging coefficient
翻孔系数
2) flanging coefficient
翻边系数
1.
Through the simulation,the influences of strain hardening exponent n,coefficient of normal anisotropy r and flanging coefficient K on hole-flanging formability were analyzed.
通过模拟,分析了应变强化指数n、厚向异性系数r以及翻边系数K对圆孔的翻边成形性能的影响,得到了不同K值时的减薄率与n、r值的关系曲线。
3) discharge coefficient
孔流系数
1.
Their discharge coefficients were obtained by Hughmark -O'Connell's correlation.
在直径500 mm的有机玻璃塔内,以空气为物系,对普通筛孔塔板和锥形筛孔塔板的干板压降进行测定,根据Hughmark-O'Connell关联式计算得到孔流系数。
2.
After comparing with three kinds of sieve trays under the same conditions, the results show that dry plate pressure drop of upper taper sieve trays is less 20% ~ 30% than that of common sieve trays, and discharge coefficient of upper taper sieve trays is larger than that of common sieve.
本文研究了普通筛板、下锥形筛板和上锥形筛板的干板压降情况，考察了孔径、板厚、孔间距、锥形斜角等因素对孔流系数的影响，提出对于大孔径筛板，在用孔流系数关联干板压降时，并不是都要引入修正系数1。
4) the coefficient of borehole reaming
扩孔系数
1.
Based on the site situation of interrupting work of bored piles during the construction of Maoliger Large Bridge in Hohhot-Hailar Corridor,Inner Mongolia,such as the collapse of boring wall,interrupting piles,on large side of the coefficient of borehole reaming,the rock stratum being stiff,etc.
针对内蒙古茂力格尔大桥基础钻孔桩施工过程中容易出现的坍塌断柱、扩孔系数偏大、岩层硬等实际情况,采取相应的质量保证措施,确保大桥钻孔桩的工程质量。
5) pore pressure coefficient
孔压系数
1.
,pore pressure coefficient B-bar control method is introduced.
简要介绍了一种软基上填筑堤坝施工安全的监控方法—孔压系数B值控制法。
6) hole-openi ng factor
开孔系数
补充资料：翻音不翻字
【翻音不翻字】
翻音不翻字者，谓如卍字，以此方万字之音翻之，而卍字之体，犹存梵书是也。
翻音不翻字者，谓如卍字，以此方万字之音翻之，而卍字之体，犹存梵书是也。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条