1) bipolar dynamo
二极发动机
2) bipolar motor
二极电动机
3) organic light-emitting diodes
有机发光二极管
1.
Recent advancements in white organic light-emitting diodes;
白光有机发光二极管的最新进展
2.
Organic light-emitting diodes using LiF as a cathode injection layer are fabricated by vapor thermal deposition.
使用真空热蒸发方法,制备了结构为ITO/TPD/Alq3/LiF/Al的有机发光二极管,其中LiF用作阴极注入层,LiF超薄层的加入,增强了电子注入,降低了启亮电压,提高了器件的发光效率和亮度。
3.
This paper explores the application probability of the organic light-emitting diodes(OLED) in the fields like sensors and optoelectronic devices.
对有机发光二极管在传感器和光电子器件上应用的可能性进行了初步研究。
4) Organic light emitting diode
有机发光二极管
1.
A single controller/driver chip was developed for a 96×64 pixel panel of a passive matrix organic light emitting diode(PM-OLED).
为了支持并利用有机发光二极管(OLED)显示技术,设计一种适用于96×64无源OLED(PM-OLED)的显示控制与驱动芯片。
2.
Working principle of organic light emitting diode based on two thin film transistors(TFT) and four TFT is introduced.
介绍了两管薄膜晶体管(TFT)和四管TFT有源驱动有机发光二极管工作原理,结合TFT工作条件限制以及实现显示的要求完成了四管TFT有源驱动有机电致发光单元像素的设计,利用Hspice软件验证了单元像素的设计结果,最大输出电流为2。
3.
A method of matrix display of organic light emitting diode is presented.
介绍了实现有机发光二极管 (OL ED)图形显示的一种方法 。
5) organic light-emitting diode
有机发光二极管
1.
Using a spinning polymer layer of poly(N-vinylcarbazole)(PVK) as hole transport layer(HTL) and an evaporated layer of tris(8-hydroxy)quinoline aluminum(Alq_3) as electron transport layer and emission layer,the organic light-emitting diodes(OLEDs) with the structure of ITO/PVK/Alq_3/Mg∶Ag/Al have been fabricated.
采用聚乙烯基咔唑(PVK)作为空穴传输层,8-羟基喹啉铝(Alq3)作为发光层,制备了结构为ITO/PVK/Alq3/Mg∶Ag/Al的有机发光二极管(OLED),通过测试器件的电流?电压?发光亮度特性,研究了空穴传输层厚度对OLED器件性能的影响,优化了器件功能层的厚度匹配。
2.
Recent progress about structures and properties of organic light-emitting diodes(OLEDs) based on small molecular materials with emphasis on devices relating to RGB and white was reviewed.
综述了以有机小分子发光材料为基础的红绿蓝和白光有机发光二极管的结构、发光性质,简要介绍了其应用前景和发展趋势。
6) OLEDs
有机发光二极管
1.
The Model of Carriers Transport and Recombination on the Classical Bilayer OLEDs;
典型有机发光二极管中载流子传输和复合模型
2.
The power consumption of light sources used for LCD backlight unit are described in detail, besides fluorescent lamps (FLs), the principle, properties of field emission display (FEDs), light emitting diodes(LEDs)and organic light emitting diodes(OLEDs)and comparison between each other are also presented as well.
除了荧光灯(FLs)外还介绍了场致发射显示器(FEDs)、发光二极管(LEDs)和有机发光二极管(OLEDs)的原理、特性及优缺点比较。
3.
Organic light-emitting diodes(OLEDs) using TiO_2 ultra-thin films as a hole injecting buffer layer of different thicknesses were prepared by RF magnetron sputtering.
采用磁控溅射方法在ITO表面制备了不同厚度的TiO2超薄膜用做有机发光二极管(OLEDs)的空穴缓冲层,使OLEDs(ITO/TiO2/TPD/A lq3/A l)的发光性能得到很大改善。
补充资料：航空发动机推重比(见航空发动机推力)
航空发动机推重比(见航空发动机推力)
thrust to weight ratio of aeroengine
hQngkong角dong)1 tuizhongbi航空发动机推重比〔thros*:。wdgh:ra-tio of aeroengine)见航空发动机推力。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条