1) voltage feedback
电压反馈(电信)
2) feedback voltage signal
反馈电压信号
3) voltage feedback
电压反馈
1.
At the same time, a more practical voltage feedback circuit is formed by adopting the photoelectric coupling circuit.
介绍了一种用功率开关器件组成的自动焊控制电路 ,主电路采用桥式可逆斩波电路及相应控制方法 ,同时在反馈环节中采用光电藕合器件组成了较实用的电压反馈电
2.
The charging technique with L-C constant-current converter is adopted, and the repeated charging and discharging process of the device is controlled by voltage feedback.
研制了一种检测氧化锌避雷器阀片的重复频率充放电装置,采用L C恒流充电技术,通过电压反馈法控 制充放电运行过程。
3.
This paper introduces and compares the circuit of voltage feedback in the PWM controller of the current mode,designs a kind of circuit with voltage feedback of UC3846 based on the current mode,which satisfies the stable output in the high frequency circuit,nonlinear load circumstance.
介绍并比较了电流模式PWM控制器中电压反馈的基本电路,设计出了基于电流控制型PWM控制芯片UC3846的电压反馈的实用电路,该电路能满足在高频电路、非线形负载情况下稳定的输出。
4) feedback voltage
反馈电压
5) piezoelectric voltage feedback
压电电压反馈
1.
On the basis of geometric features of piston pinhole and the characteristics of piezoelectric actuators, which have infinite resolution, high stiffness, high frequency and its sensor function, a piezoelectric voltage feedback control system was put forward.
根据活塞异形销孔几何特征和压电陶瓷驱动器控制精度高、刚性好和高频响特点及其具有的传感功能,提出了压电电压反馈的控制系统,并在该系统中引入重复控制和干扰通道的开环前馈控制,从而提高了系统的稳定性和跟踪精度。
6) voltage negative feedback
电压负反馈
1.
Due to the application of design principle of the switching power supply,voltage negative feedback was performed in the DC push-pull boost module,and the high voltage was to be steady.
应用开关电源的设计原理,在直流推挽升压模块中,采用了电压负反馈,使得升压后的高电压具有良好的稳定性;逆变部分采用单片机数字化SPWM控制方式,以尽可能地减少谐波。
2.
The feedback factor of the voltage negative feedback circuit is the function about parameters:R F,R L,r o,r i,A o.
分析研究了在电压负反馈放大电路中,反馈系数F与电路参数RL,ro,Av等的关系。
补充资料：国际电信联盟标准(见国际电信联盟)
国际电信联盟标准(见国际电信联盟)
standards of ITU: see International Telecommunication Union; ITU
切网1 Ulan欠jnL心n厅泊ngb泊。zhun国际电伯联盟标准(，tan由Ids际电信联盈。of TYLJ)见国
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条