2) polarization resistance
极化电阻
1.
Measurements of corrosion potential and the polarization resistance were used to investigate the electrochemical behavior of HSn70-1AB and BFe30-1-1copper alloys in medium containing sulfate reducing bacteria.
结果表明,铜合金表面生物腐蚀与SRB的生长特性密切相关,SRB处于指数生长期时,HSn70-1AB和BFe30-1-1铜合金的自腐蚀电位(Ecorr)和极化电阻(Rp)均迅速下降,腐蚀加剧,且后者腐蚀速度大于前者;而当SRB进入稳定生长阶段,两种合金的Ecorr和Rp均缓慢下降,腐蚀速度减缓,且二者腐蚀速度接近。
2.
Composite cathode could improve the performance and efficiency of the solid oxide fuel cell at high temperature,decrease the over-potential,polarization resistance and interfacial resistance.
复合阴极可以提高固体氧化物燃料电池(SOFC)在高温下的性能和效率,降低过电位、极化电阻和界面电阻。
3.
The codeposition of nickel—phosphorus alloys in phosphorous acid system as well as their corrosion resistance in neutral sodium chloride solutions were investigated using various techniques such as electrodepositing at constant current, corrosion potential and polarization resistance, XRD, SEM and XPS.
用恒电流沉积、腐蚀电位和极化电阻等方法研究了 H3PO3体系中 Ni-P合金的电沉积及其镀层的耐蚀性能 ,用 XRD、 XPS、 SEM检测了镀层的晶形、组成和表面形貌 ,探讨了沉积条件对镀层耐蚀性能的影响 。
3) anodic resistance
阳极电阻
1.
Hence to master the alternation regularity of anodic resistance and voltage-drop could provide indispensable foundation to energy saving.
铝电解槽的阳极压降约占槽电压的10%,因此掌握阳极电阻、压降的变化规律能为节能降耗提供必要依据。
4) electrode impedance
电极阻抗
1.
Study on test of electrode impedances of Nucleus′cochlear implant;
Nucleus人工耳蜗电极阻抗测试的研究
2.
Objective To investigate the changes in electrode impedance and the clinical significance in cochlear implant users.
目的研究人工耳蜗植入以后电极阻抗的变化规律及其临床意义。
5) resistive anode
电阻阳极
1.
The detecting system is based on the residual gas ionization principle and consisted of electrostatic collecting plates, micro-channel plates and a resistive anode.
介绍了一种以微通道板和电阻阳极所构成的位置灵敏探测器为基础、用于兰州重离子加速器束流诊断的新型剩余气体电离束流剖面探测系统 。
6) base resistance
基极电阻
1.
Bad noise performance of conventional device is mainly caused by the high base resistance.
常规工艺制作的SiGe/Si HBT高频噪声性能不理想的主要原因是其基极电阻较大,为减小基极电阻从而达到改善其高频噪声的目的,本文采用离子注入自对准工艺方法进行器件制作,并测试出器件的直流与最小噪声系数有显著改善。
2.
This paper presents an improved method for extracting the emitter resistance of HICUM model after the analysis and contrasting of the existing BJT equivalent circuit model emitter and base resistances parameters extraction techniques.
对现存BJT等效电路模型发射极与基极电阻参数提取方法进行了总结和对比,并针对HICUM模型改进了提取发射极电阻的方法。
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条