1) electric lamp filament
电灯灯丝<冶>
2) filament temperature
灯丝温度<冶>
3) ion(ization) gauge
灯丝电离真空计<冶>
4) filament voltage
灯丝电压
1.
By using C8051F040 SCM to control the neutron tube′s filament voltage,the target voltage and the pulse of the anode,the downhole tool can work at an ideal state.
通过C8051F040单片机对中子管的灯丝电压、靶压以及阳极脉冲进行控制,使其工作在一个理想状态,是提高仪器测井效率、延长中子管使用寿命的重要手段。
2.
The curve shape and the measurement accuracy of Franck-Hertz experiment are analyzed by changing the main parameters of temperature(T),filament voltage(UF),first grid bias(UG1K),hinders volta.
利用改造后的第一代夫兰克-赫兹实验仪,通过计算机输入不同实验参量,得到相应实验条件的曲线及数据;在同一坐标界面中显示不同参量的多条实验曲线,分析了温度T、灯丝电压UF、第一栅极电压UG1K、阻滞电压UR及第二栅极电压UG2K对夫兰克-赫兹实验曲线形状及测量精度的影响,进而确定了各参量的最佳值。
5) filament resistance
灯丝电阻
1.
However, because the filament resistance varies nonlinearly under the influence of temperature, the error of the calculating result is always great.
由于灯丝电阻受温度影响而呈非线性变化,因而计算的结果一般误差很大。
6) filament current
灯丝电流
1.
This paper introduces the automatical monitoring and control of the filament current of a magnetron the key component in a micro wave energy application system with MCS 96 series 8098 one chip computers, and presents the programme block diagram of its design.
介绍了如何利用ＭＣＳ—９６系列８０９８单片机对微波能应用系统中的关键部件—磁控管灯丝电流实行自动监测与控制，并给出了设计程序框图。
2.
The operation principle of the ion source circuits in the Eaton NV10-80 high current implanter is described in detail, including ARC voltage, filament current, gas pressure regulation and vaporizer temperature control.
本文较为详细地分析了EatonNV10 - 80大束流离子注入机离子源电路工作原理 ,包括ARC电压、灯丝电流、气源压力调节及固体源坩埚温度控制的电路工作原理 ,同时 ,又针对常见离子源故障解决作了剖析。
补充资料：融融冶冶
1.美好艳冶。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条