1) magnetic tape switching unit
![点击朗读](/dictall/images/read.gif)
磁带转接部件
2) magnetic tape processing unit
![点击朗读](/dictall/images/read.gif)
磁带处理部件
3) magnetic tape file unit
![点击朗读](/dictall/images/read.gif)
磁带外存储器部件;磁带文件部件
4) Rotary joint
![点击朗读](/dictall/images/read.gif)
旋转连接部件
1.
The thesis is the technical improvement of existing Signal Transmission System of Rotary joint Component in Vehicle.
论文是对现有军事车辆旋转连接部件综合信号传输系统的技术改进。
5) communication switching unit
![点击朗读](/dictall/images/read.gif)
通信转接部件
6) hypertape control unit
![点击朗读](/dictall/images/read.gif)
快速磁带控制部件
补充资料:将UG里的一个装配部件输出成单个部件文件
法一:
- 关闭(turn off)FileàOptions->Load Options下"Partial Loading "选项
- 打开装配部件
- 选择File->Export->Part
- 在"Part Specification"下选择"new"
- 选择"Specify Part",指定输出部件文件名称及位置
- 将"Object Selection Scope"设定为"All Objects"
- 选择"Class Selection->Select All"高亮所有对象
- 按"OK"
该种方法特点:每一个部件的特征都会汇集在新部件的MNT里。可以方便编辑。
法二:
- 闭(turn off)File->Options->Load Options下"Partial Loading "选项
- 打开装配部件
- Application->Assembly
- Assemblies->Components->Create New,给出想要输出的部件文件名及路径。
- 如下图1,在ANT上双击新产生的部件文件,使其成为工作部件。
- Assemblies->WAVE Geometry Linker,将设置改为"Body",选择所有组件的体。
- 将"Create Non-associative"开关设为"On",见下图2
- 将产生的部件设成显示部件,仅保存刚产生的新部件,不保存旧的装配部件。
![]() 图1 | ![]() 图2 |
该种方法特点:每一个部件在新部件的MNT里只会显示一个link的特征。没有相应特征可以编辑。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条