1) heat-transfer characteristic
传热特性[冶]
2) heat transfer characteristics
传热特性
1.
Energy conservation and heat transfer characteristics of phosphorus reactor;
热法磷酸燃磷塔的节能改造与传热特性研究
2.
Numerical study on flow and heat transfer characteristics of 3D turbulent impinging jets;
三维湍流冲击射流流动与传热特性的数值研究
3.
Analysis on the heat transfer characteristics inside and outside the tubes of the radiator of the santana automobile;
桑塔纳轿车散热水箱管内外传热特性的分析研究
3) heat transfer characteristic
传热特性
1.
Visual experiment study on operation and heat transfer characteristics of pulsating heat pipes;
脉动热管运行和传热特性的可视化实验研究
2.
Adopting the corrected coefficient,the result of calculating heat transfer characteristics of pulverized coal blending BFG are consistent with the experimental results.
以某350 MW煤粉/高炉煤气混烧电站锅炉为研究对象,通过采用试验研究与热力计算相结合的方法,对混烧高炉煤气后锅炉对流受热面的传热系数进行了修正,满足了掺烧气体燃料后的传热特性,保证了热力计算程序的准确性,对锅炉的优化运行具有指导意义。
3.
The operation principle and the heat transfer characteristics of the exchanger were studied experimentally.
介绍了一种新型中间热媒式换热器———常压相变-液浴式换热器,并通过实验对该换热器的工作原理和传热特性进行了研究。
4) heat transfer
传热特性
1.
Lattice Boltzmann Simulation of Gaseous Micro-flows and Heat Transfer;
气体微尺度流动和传热特性的格子Boltzmann模拟研究
2.
At the same time, the transient heat transfer characteristics of the MSW lump decides the stay time of the MSW in incinerator and effects on the operation feature of the combustion equipments.
考虑垃圾洁净燃烧炉内高温烟气对流及辐射换热 ,应用有效导热系数法 ,对不同形状 (球体、圆柱体、立方体 )不同特征尺寸具有多孔介质特性的垃圾团块非稳态传热特性进行了数值模拟 ,结果表明 :垃圾团块中心温度稳态值大小与换热边界流体温度大小密切相关 ,且高温流体换热表面越多 ,团块内部稳态温度值越大 ;垃圾团块的形状对其在垃圾洁净燃烧炉内加热升温特性影响较大 ,在相同特征尺寸(L =V F)下 ,球形体垃圾团块升温速度最快 ,柱形体次之 ,方形体最小 ;随着垃圾团块特征尺寸增加 ,垃圾团块中心单元温度达到稳定的时间明显增长 ,特别是特征尺寸大于 10时 ,稳定时间增加幅度较大 ,且特征尺寸越大 ,稳定时温度越小 ,越不利于垃圾的挥发份析出 ,不利于垃圾燃尽。
3.
The inlet,average and variable thermal properties were adopted respectively to numerically simulate the 3D conjugate heat transfer and laminar flow in rectangular microchannels with a hydraulic diameter of 0.
将不同方法下局部和平均流动与传热特性的计算结果与新近文献中的实验结果、常见关联式及近似理论解进行了对比分析。
5) heat transfer performance
传热特性
1.
Design for new-style and hot-water car heater and research on its heat transfer performance;
新型水暖式汽车暖风装置的开发与传热特性分析
2.
Its heat transfer performance was studied by a series of experiments with heat flux from 1 kW/m2 to 5 kW/m2,working temperature from 30℃ to 60℃ and gradient of evaporation end from 10°to 90°.
采用铜管模拟分离式热管蒸发段,以R22为工质,在热流密度1~5 kW/m2、蒸发温度30~60℃和蒸发段倾角10°~90°范围内,研究了这种分离式热管的传热特性。
3.
The heat transfer performance of a rectangular fin during periodic fin base temperature change is studied under simultaneous action of radiation and convection.
研究在辐射和对流同时作用下肋根温度作周期性变化时矩形肋片的传热特性。
6) thermal expansion characteristic
热膨胀特性(冶)
补充资料：融融冶冶
1.美好艳冶。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条