1) shroud fillet radius
齿侧凸缘圆角半径
2) changeable punch-nose angle
凸模变圆角半径
1.
Aimed at deformation characteristics of the complex box during extrusion, a new class of flow arrest groove with direction and changeable punch-nose angle were brought forward and designed At the same time, the feasibility of flow arrest groove and changeable punch-nose angle was proved by experiments.
针对某复杂盒形件的不规则形状和挤压变形时金属的不均匀流动,提出设计了挤压模的具有方向性的止流槽和凸模变圆角半径,并通过实验验证了止流槽和凸模变圆角半径控制金属合理流动的可行性,为同类型不规则或非对称零件的挤压成形提供了新思路。
3) the radius of the round corner of concave-convex die
凸凹模圆角半径
1.
In this article,an experimental research on the thermal deep-drawing process of (AZ31) magnesium alloy sheets is carried out,and the effects of the radius of the round corner of concave-convex die and the conditions of friction and lubrication on thermal deep-drawing process of(AZ31) magnesium alloy sheets are analysed.
对AZ31镁合金板热拉深进行了实验研究,分析了凸凹模圆角半径大小、摩擦与润滑条件对AZ31镁合金板热拉深成形的影响。
4) punch corner radius
凸模圆角半径
1.
Study the rebound in the various circumstances,for example,the thick of sheet,punch the gap between die,punch corner radius etc.
用实验的方法探求无边压力情况下的板材回弹问题,分别就材料性能、板料厚度、凸模圆角半径、凸凹模间隙、凹模跨度、摩擦系数等诸多因素对板料回弹的影响做出了分析。
5) radius at tooth tip
齿顶圆角半径
6) radius of tooth fillet
齿根圆角半径
补充资料：锻件圆角半径
锻件圆角半径
corner radius of forging
duanlian yuanliao baniing锻件圆角半径(eorner radius of forging) 锻件图上光滑地连接锻件各交接面的圆弧半径，作用是使金属易于流动而充满模槽。如图所示，锻件凸部的圆角半径叫外圆角半径，用r表示;锻件凹部的圆危半径叫内圆角半径，用R表示。内圆角半径R应比外圆角半径r取大些，以利于锻件脱模。秘 国角半径示意图 (李体彬)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条