1) sloppy cut,slop cut
不合格馏分
2) disqualification
不合
1.
In order to find out the causes of 16MnR plate disqualification by ultra-sonic test,the samples from the flaw location are observed and detected with scanning electron microscope and energy spectrum to analyze the microstructure and component.
为找出16MnR钢板超声波检测不合的原因,在检测缺陷部位取样,借助电子显微镜和电子探针,对钢板组织和微区成分进行了分析。
3) unqualified property
性能不合
4) unqualified thickness
厚度不合
1.
The result shows that the main product causing QO is Q345 series low-alloy steel and unqualified property,unqualified thickness,deficient dimension and petted surface are the main QO items.
运用MINITAB软件对济钢中厚板厂2005年质量异议情况进行分析,可知Q345系列低合金钢是产生质量异议的主要产品,性能及厚度不合、短尺及凹坑是主要异议项目,加热及轧制制度不合理是产生质量异议的主要原因。
5) irrationality
不合理性
1.
Analysis on irrationality of determining coal spontaneous combustion with chromatographic method of fluid oxygen adsorption;
流态色谱吸氧法测定煤自燃倾向不合理性分析
2.
The Appraising Standard on the Rationality of Trade Policy and the Irrationality of Anti-dumping;
论贸易政策合理性的评价标准及反倾销的不合理性
3.
The irrationality of operation mechanism of large flowrate and small temperature difference is analyzed detailedly,and proposed the scientific operational mechanism.
详细分析了“大流量、小温差”运行机制的不合理性,从中提出了科学的设计运行机制。
6) unqualified inflection preformance measures
反弯不合
参考词条
补充资料：不合格百分率计数检验的序贯抽样方案
不合格百分率计数检验的序贯抽样方案
sequential sampling plans for inspection by attributes for percent nonconforming
加hege比ifen.o Jishu Jianvan dex叩uanC伙泪四叩fa叩’On不合格百分率计数检验的序贯抽样方案(se-quenti吐~plingp】川15 for inspection场attributesforpe二ni nonconfo丽ng)逐个地(或成组地)抽取个体，但事先并不固定它们的个数，根据事先规定的规则，直到可以做出接收或拒收批的决定为止。作为代表性的是IEC 1 123:l卯l标准。 设在n.抽试产品中出现;个不合格，且抽样方案给出:，h两数。判决规则如下:①如;n一h〕r，则接收;②如:n一h
说明：补充资料仅用于学习参考，请勿用于其它任何用途。