2) laminated glass
夹层玻璃
1.
Experimental study on load bearing capacity of point-supported mid-hollow and laminated glasses;
点支式中空和夹层玻璃承载性能的试验研究
2.
Simulation Analysis on Impact Fracture Behavior of Laminated Glass;
夹层玻璃的冲击破坏仿真分析研究
3.
The quality of PVB film in laminated glass directly affects the final product's quality and service life.
在夹层玻璃生产中PVB胶片的质量直接影响制成品的质量和使用寿命。
3) sandwich glass
夹层玻璃
1.
At the same time, the problem in the preparation of sandwich glass and their resolvents were also discussed.
并对光固化安全夹层玻璃制备过程易出现的问题和相应的解决办法进行了探讨。
2.
In this research work, effects of interface properties on the adhesion of sandwich glasses were investigated.
鉴于夹层玻璃是由两种或多种透明固体基材通过热压工艺复合在一起,笔者就材料界面性质对粘结性能的影响进行了深入的研究。
4) glass coating
玻璃涂层
1.
The effects of processing parameters and adding rare earth on the corrosion resistance of glass coatings on metal surface were studied by means of electrochemical test, immersion test,pitting test and scanning electron microscope.
利用斑点试验、点蚀试验、电化学测试及扫描电镜等方法 ,研究了熔敷温度、保温时间和稀土添加量等工艺参数对热熔敷法制备的玻璃涂层耐蚀性的影响 ,探讨了添加稀土提高玻璃涂层耐蚀性的机理。
2.
The corrosion mechanism of flame sprayed glass coatings was studied in this paper.
研究了手工火焰喷涂玻璃涂层的腐蚀破坏机理。
3.
The impact test, the thermal shock test and the scanning electron microscopy were used to investigate the effect of rare earth oxide on the adhesiveness between the glass coating and the base metal.
利用冲击试验、热震试验和扫描电镜等方法研究了添加氧化铈对玻璃涂层与金属基体密着性的影响规律。
5) double glazing
双层玻璃
1.
Experimental study on heat resistance under variational double glazing air layer thickness;
双层玻璃空气层厚度变化对热阻影响的实验研究
6) Laminated Glass
层合玻璃
1.
The Experimental Studies of Thermal Strain of Laminated Glass by Moire Interferometry Method;
应用云纹干涉法进行层合玻璃热应变的实验研究
2.
Laminated glass unit .
风挡材料是一种层合玻璃,层合玻璃是由较大弹性模量的透明材料和较小剪切模量的软胶层层合而成,两层透明材料通过中间的软胶层粘结。
补充资料：N,N-二缩水甘油2,4,6-三溴苯胺玻璃布层合板
分子式：
CAS号：
性质：以三溴苯胺环氧树脂为基料的玻璃布层合板。耐燃性好，相对密度>1.98。机械强度除冲击强度(190kJ/m2)和剪切强度(119MPa)外，其他略次于E-51环氧树脂。将三溴苯胺环氧树脂与有关添加剂配成胶液后，手工糊于玻璃布上，叠层并层合固化即得。可用于要求耐燃的航空、船舶和机电行业。
CAS号：
性质：以三溴苯胺环氧树脂为基料的玻璃布层合板。耐燃性好，相对密度>1.98。机械强度除冲击强度(190kJ/m2)和剪切强度(119MPa)外，其他略次于E-51环氧树脂。将三溴苯胺环氧树脂与有关添加剂配成胶液后，手工糊于玻璃布上，叠层并层合固化即得。可用于要求耐燃的航空、船舶和机电行业。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条