说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 标准开式回路头盔
1)  standard open circuit helmet
标准开式回路头盔
2)  standard deep sea helmet
标准重潜水头盔
3)  helmet targeting
头盔瞄准
4)  standard deep sea helmet
标准深海潜水头盔
5)  open loop
开式回路
1.
Adopting R123 as the working medium,the effects of liquid filling ratio and heating mode on heat transfer limit were qualitatively analyzed on the open loop pulsating heat pipes test fig consisted of 40 elbows bent by fine copper tubes with inner diameter of 1 mm and 2 mm,and the experimental values were compared with calculated values by the Katpradit\'s correlations for heat transfer limit.
在由内径分别为1 mm和2 mm的细铜管弯曲而成的2组40弯头开式回路脉动热管试验装置上,采用R123为工作介质,定性分析了充液率及加热方式对传热极限的影响,并将试验值与Katpradit传热极限关联式的计算值进行了比较,结果表明:随着充液率的提高,传热极限先增大而后减小,存在一个最佳充液率(约50%);在3种加热方式中,垂直底部加热有助于脉动热管取得较大的传热极限值,而垂直顶部加热则对应较小的传热极限值。
6)  helmet mounted sight
头盔瞄准具
1.
After introducing optic-electric method on measurement and calculation of lag line in helmet mounted sight, the article proposes a new method of measuring position of lag line with CCD camera image, which can overcome shortcoming of mechanical deviation and working in real time.
分析了某型头盔瞄准具的头位测量原理,介绍测量方法,并在原数学模型的基础上,提出了一种新的测量方法,该方法可以在飞行模拟器上使用,也可经适当改装机载使用。
补充资料:德国国家标准(见德国标准化学会、德国标准体系)


德国国家标准(见德国标准化学会、德国标准体系)
National Standards of Germany: see Deutsches Institut für Normung, DIN;standards system of Germany

  Oeguo Guol心日icozhun德国国家标准(Natio.吐S加Ln山切曲of Gen”旧ny)见德国标准化学会;德国标准体系。
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条