1) crater lamp
凹孔放电管
2) Discharge Crater
放电凹坑
3) discharge aperture
放电孔径
1.
Under other constant processing parameters condition,LD10 aluminum alloys were treated and then the scanning electron microscope was used to observe the microstructure of the coating surface; finally the influence of each kind of solution composition on the electric discharge aperture in solution which consists of KOH,Na2SiO3,KF and (NaPO3)6 were researched.
在其他加工参数固定的条件下,对LD10铝合金试件进行处理,然后采用扫描电镜对膜层表面显微结构进行观测分析,研究由KOH、KF、Na2SiO3、(NaPO3)6构成的溶液中各种成分浓度的变化对膜层表面放电孔径的影响。
5) marked voltage of discharge tube
放电管放电电压
6) Arrester
[英][ə'restə] [美][ə'rɛstɚ]
放电管
1.
DC Spark-over Voltage Auto-testing System for the Arrester;
气体放电管直流击穿电压自动测试系统的研制
2.
A novel multi cell structure for semiconductor arrester is proposed.
在半导体放电管的版面设计上提出了多元胞结构版图。
补充资料：凹模壁厚及凹模垫板尺寸
型腔壁部投影面积 壁 厚， 毫 米
F， 厘米2 h1 h2 h3 h4 h5
<5 15~20 30~40 <=10 15~20 30~40
>5~10 20~25 40~50 10~15 20~25 40~55
>10~50 20~30 50~60 15~20 20~30 55~65
>50~100 30~35 60~75 20~25 30~40 65~70
>100~200 35~40 75~85 25~30 40~50 70~75
>200 >40 >85 30~35 50~60 >80
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条