1) mixing intensity
(混合室)搅拌强度
2) mixing chamber
混合[混气,预燃,搅拌]室
3) Agitation intensity
搅拌强度
1.
The influence of agitation intensity and agitator types on size of latex particle, polymerization rate, and latex stability during emulsion polymerization is reviewed.
综述了乳液聚合过程中搅拌强度对乳胶粒径、聚合反应速率、乳液稳定性的影响及搅拌器形式的影响。
2.
Meanwhile,some factors which influence on the morphology of filamentous microorganisms,such as agitation intensity,dissolved oxygen concentration and dilution rate,were also discussed here.
影响丝状微生物形态的主要因素有搅拌强度、溶氧浓度和稀释率等。
4) stirring intension
搅拌强度
1.
The Effect of Stirring Intension on the Performance of a Denitrifying Moving Bed Biofilm Reactor (MBBR);
搅拌强度对反硝化紊动床的特性影响研究
5) agitation rate
搅拌强度
1.
The desulfurization and the leaching of Mn 2+ were studied under different agitation rate.
考察在不同搅拌强度下SO2 的脱硫率及锰离子浸出率 ,在低转速范围 ,溶液中脱硫反应主要以MnO2 和SO2为主 ,其产物主要为硫酸锰。
2.
The effect of agitation rate on desulfuration reaction mechanism of pyrolusite pulp was investigated.
研究了搅拌强度对软锰矿浆湿法脱硫反应的影响。
6) Stirring intensity
搅拌强度
1.
Effect of stirring intensity on the structure of white carbon;
搅拌强度对白炭黑结构的影响
2.
Study on crystal shape of calcium sulfate and the effect of stirring intensity in WPA production
硫酸钙结晶形态研究及湿法磷酸生产中搅拌强度对硫酸钙晶形的影响
3.
The mass transfer coefficient is found to vary in a linear way with stirring intensity when the flat jet thickness is 3 mm or 4 mm.
采用水(煤油(溶有β-萘酚)体系对平面射流连续反应器的传质系数进行了测定,实验结果表明:体积传质系数随搅拌强度的增大而增大,平面射流厚度为3和4 mm时,体积传质系数与搅拌强度有较好的线性关系;从体积传质系数的大小分析,平面射流连续反应器具有较好的传质能力,有潜在的较好的反应动力学条件。
补充资料:表光合强度(见光合强度)
表光合强度(见光合强度)
forecast of sowing or transplanting time
b iaoguanghe qiangdu表光合强度见光合强度
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条