1) Tetrabenzylthiuramdisulfide
橡胶促进剂 TBzTD
2) rubber accelerator
橡胶促进剂
1.
The paper summarized the development trends of the rubber accelerator in the world and production situation ofthe rubber accelerator in China.
本文介绍了世界橡胶促进剂发展趋势和我国橡胶促进剂生产现状。
2.
Research and development history of rubber accelerator is briefed.
简要介绍了橡胶促进剂的研发历史 ,重点介绍了近年来国际顶级助剂公司研究开发的新品种 ,尤其是耐热性能优异的新品和创新型超促进剂新品。
3) rubber accelerator M
橡胶促进剂M
1.
The rubber accelerator M contains a great deal of water after the acidifying process.
由于橡胶促进剂M在酸化后含有大量的水分,前期研究表明通过添加表面活性剂预处理可以有效降低固液分离后滤饼的含水量。
4) rubber accelerator wastewater
橡胶促进剂废水
1.
It is difficult to treat the rubber accelerator wastewater to reach the standard by physical chemistry process, moreover the movement cost is higher; the rubber accelerator wastewater contains much non-degradability organic matter、bad biodegradability, as well as change in water flow and quality, therefore it is not very ideal to treat this wastewater by the bio-chemistry method.
橡胶促进剂废水含较多的难降解有机物，可生化性差，而且其水量水质变化大，故直接用生化方法处理该废水效果也不是很理想。
2.
In this article,ozone oxidation method was used to pretreat the rubber accelerator wastewater;the results showed that the COD removal rate is more than 20% on average.
研究了用臭氧预处理橡胶促进剂废水的方法和效果,并通过改变pH、填料和助剂等条件以确定最佳反应工况,结果表明,臭氧在处理该种废水时COD的去除率在20%以上,在调节pH至8～9且投加大理石填料和助剂的情况下,COD的去除率可达44%,大大降低了后续生物处理的有机负荷,提高了可生物氧化性。
5) Zinram
橡胶促进剂PZ
6) N-Cyclohexyl-2-benzothiazolesulfenamide
橡胶促进剂 CZ
补充资料：橡胶促进剂 TBzTD
分子式：C30H28N2S4
分子量：544.82
CAS号：10591-85-2
性质：熔点124°C。
分子量：544.82
CAS号：10591-85-2
性质：熔点124°C。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条