1) saturation field strength
饱和场强
2) saturation intensity
饱和强度
1.
The dependence of DFWM saturation intensity on foreign gas pressure is measured and found to be Isat∝ p0.
研究了入射激光能量密度,外加气体(N_2,CO_2,NO_2)对碘的简并四波混频(DFWM)光谱和信号强度的影响,测定了I_2的DFWM信号的饱和强度与外加气体压强之间的关系。
2.
In this paper,the structure and the spectrum of the saturable Bragg reflector are generalized in detail,and the relation between the absorption coefficient,saturation intensity and the inherent parameters of the SBR is derived from the density matrix equations.
分析了SBR的结构和光谱特性 ,并从密度矩阵方程出发导出了SBR的吸收系数、饱和强度与SBR的固有参数之间的关系 ,分析了SBR在固体激光器中的锁模机理 ,得到了SBR在固体激光器中锁模的基本条件 ,结果表明 ,SBR能够用于飞秒固体激光器锁模并提高锁模脉冲的质
3.
The prerequisites to the operation of passive mode-locking laser are derived quantitatively, which include the upper limit of pumping rate and the lowrt limit of the saturation intensity of laser medium.
定量地导出了被动锁模激光器运转的先决条件，它们是泵浦速率的上退和激光介质饱和强度的下限。
3) maximal strong solution
饱和强解
1.
The behavior and existence of strong solutions to the second order non-autonomous functional(differential)-iterative equation (t)+p(t)(t)=a(t)x(t)+b(t)x(x(t)) are studied,the condition of existence of strong solution across any point of the region ｛(t,x)｜0<x≤t｝ is given,the obtained(conclusion) has maximal strong solutions across any point of the set ｛(t,x)｜0<x=t｝.
x(t)=a(t)x(t)+b(t)x(x(t))的强解的存在性及其性态,给出了过区域{(t,x)|0
2.
The paper studies the behavior and existence of strong solutions of the second orderlinear autonomous functional --iterative equation x"(t) =x(t)+x(x(t)))satisfying the performance,existence and delay of the initial condition x(o)= and x (o)=,and comes to the conclusion thatthere are maximal strong solutions of the initial value problem.
本文研究了二阶自治线性迭代泛函微分方程ｘ”（ｔ）＝ｘ（ｔ）＋ｘ（ｘ（ｔ））满足初始条件ｘ（б）＝б，x'（б）=θ强解的性态、存在性及延拓问题，得出了存在饱和强解的结论。
4) saturation intensity
饱和光强
1.
The equations for the small-signalgain, the saturation intensity, the laser output power, and the optimal output-couplingcoefficient of a resonator are presented.
利用CO2激光器的简化速率方程模型，对高功率横流连续CO2激光器特性参数进行了全面的分析和探讨，建立了光腔小信号增益系数、饱和光强参数、激光输出功率和激光耦会输出窗口最佳透射率计算公式，其计算值与实验结果吻合，为激光器的设计和运行提供了快捷、简便的计算依据。
2.
The thermooptic coefficient and saturation intensity of tea liquid are measured to be1.
２×１０－５℃１，饱和光强为５４ＫＷ／ｃｍ２。
5) maximal strong solutions
饱和强解
1.
Tbe existence of strictly monotone maximal strong solutions which can not be continuated to ∞ in the two ends are proved as μ= 0, i.
当μ＜０时，我们得到与Ｅｄｅｒ［１］和ｗａｎｇ［２］相类似的结论，也得到一些新的性质；当μ＝０时，我们得到全新的结论，证明方程（１）存在两端均不可延拓到∞的严格单调饱和强解，μ＝０是方程（１）的分支值。
6) saturation photic intensity
光强饱和
1.
According to characteristics and demand of fine tracking spot detection in space laser communication system, a kind of real-time spot detection instrument was brought forward by adjusting gain automatically , which can overcome saturation photic intensity effect.
针对空间激光通信中精跟踪光斑检测的特点与要求,本文提出使用自动增益调整的方法来克服光强饱和效应。
补充资料：饱和场强
分子式：
CAS号：
性质：铁电体处于饱和极化状态时的外电场强度。在外电场作用下铁电体内的电畴起初随外电场强度正的提高逐步取向排列，极化强度相应增加，当达某一场强时，极化强度不再增加，因电畴均按外电场方向定向排列整齐，继续增加外电场强度也不会提高极化强度，相当于饱和极化状态。烧成后的压电陶瓷要经过人工极化处理(外加直流电场)后才具有压电性。极化场强一般为2.5～4.5kV/mm，具体数值根据不同材料组成及制品尺寸而定。当外电场强度过高时，可能导致材料击穿而破坏。
CAS号：
性质：铁电体处于饱和极化状态时的外电场强度。在外电场作用下铁电体内的电畴起初随外电场强度正的提高逐步取向排列，极化强度相应增加，当达某一场强时，极化强度不再增加，因电畴均按外电场方向定向排列整齐，继续增加外电场强度也不会提高极化强度，相当于饱和极化状态。烧成后的压电陶瓷要经过人工极化处理(外加直流电场)后才具有压电性。极化场强一般为2.5～4.5kV/mm，具体数值根据不同材料组成及制品尺寸而定。当外电场强度过高时，可能导致材料击穿而破坏。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条