1) embankment stiffness
路堤刚度
1.
In order to analyze the influence of embankment stiffness on train-induced dynamic stresses in ground,a model of Euler-Bemoulli beam on an elastic half-space under moving load and the solution of dynamic stresses in ground were presented.
为了分析路堤刚度对列车引起的地基动应力的影响,给出了弹性半空间-Euler- Bernoulli梁模型在移动荷载作用下,半空间内部的应力响应解答。
2) embankment proper rigidity
路堤合理刚度
3) embankment height
路堤高度
1.
Several measures to reduce embankment height of Ku-Ku highway
库库高速公路降低路堤高度的几点措施
2.
Therefore, the reasonable density of transverse passage facilities should not only ensure the reduction of the embankment height of expressway,but also satisfy the demands of the production and living of the residents at the both sides of .
横向通道设施尤其是下穿通道的数量会影响到整条高速公路平均填土高度的高低,因此合理的横向通道设施设置密度要既能保证高等级公路路堤高度的降低,又能满足两侧居民的生产生活需求。
3.
This paper uses a dedicated finite element software PLAXIS for geo-engineering,to further explore the rules of embankment settlement deformation under different heights,and discusses relationship between embankment height and road bed settlement deformation.
采用岩土工程专用有限元软件PLAXIS,对不同高度条件下的路堤沉降变形规律进行深入研究,探讨路堤高度与路基沉降变形的关系。
4) height of embankment
路堤高度
1.
Survey and analysis on the relationship between the height of embankment of a highway in dessrt region;
沙漠公路路堤高度与沙埋关系的调查与分析
5) embankment reliability
路堤可靠度
6) subgrade modulus
路基刚度
1.
Influence of subgrade modulus on the mechanical behaviors of existing impact-compacted concrete pavement;
路基刚度对冲击压实旧混凝土路面力学行为的影响分析
2.
In order to explain the influence of subgrade modulus on dynamical cracking effect of existing impact-compacted concrete pavement,the influence of different subgrade modulus on cracking effect under impact load of quadrilateral impact roller was studied based on three dimensional elastic-plastic dynamic FEM.
目的揭示路基刚度对冲击碾压混凝土路面动力破碎效果的影响规律。
补充资料:JPZ型三向等刚度橡胶减震器
分子式:
CAS号:
性质:JPZ-type tridirective equal rigid rubber mounting 橡胶减震器的一种。具有x、y、z三个方向等刚度、等自震频率。按负荷大小可分为JPZ-1、JPZ-2两种型号。由中央金属芯柱、伞形金属罩及橡胶连接而成,模压法生产。可满足导弹控制仪等设备的隔震和抗冲击要求。
CAS号:
性质:JPZ-type tridirective equal rigid rubber mounting 橡胶减震器的一种。具有x、y、z三个方向等刚度、等自震频率。按负荷大小可分为JPZ-1、JPZ-2两种型号。由中央金属芯柱、伞形金属罩及橡胶连接而成,模压法生产。可满足导弹控制仪等设备的隔震和抗冲击要求。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条