说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 1/3次谐波共振
1)  1/3 sub-harmonic resonance
1/3次谐波共振
2)  1/3 subharmonic resonance
1/3次亚谐共振
1.
1/3 subharmonic resonance of suspended cable subjected to harmonic excitation in temperature field is studied.
研究输电线在温度场中谐扰力作用下的1/3次亚谐共振问题,应用动力学方法建立温度场中受谐扰力作用输电线的非线性振动方程。
2.
In order to study 1/3 subharmonic resonance of a thin rectangular plate on nonlinear foundation in temperature field,nonlinear dynamical equation of the system is established with the application of elastic theory.
为了研究温度场中非线性地基上矩形薄板受简谐激励的1/3次亚谐共振问题,应用弹性力学理论建立其动力学方程,应用Galerkin方法将其转化为非线性振动方程。
3.
According to the method of multiple scales for the nonlinear vibration the first approximate solution of 1/3 subharmonic resonance of the system is obtained.
根据非线性振动的多尺度解法,求得系统满足1/3次亚谐共振情况的一次近似解,并对其进行数值计算。
3)  subharmonic resonance
次谐波共振
1.
Attention is focused on the superhamonic and subharmonic resonances.
本文采用改进的L -P法研究梁的强非线性振动 ,分析了超谐波共振和次谐波共振两种情况。
2.
The crack will lead to the subharmonic resonance responses when the rotational speed is near the 1/2 or 2/3 of the critical speed.
发现裂纹会导致响应在1/2和2/3倍临界转速附近出现次谐波共振现象,在这些转速下系统响应出现了次谐波和高次谐波分量,如1/2倍频、3/2倍频、2倍频、3倍频和4倍频分量,并导致这些转速下振幅急剧增大,影响转子的稳定运转。
3.
Some numerical examples are presented to demonstrate the effects of speed pulsation and the nonlinearity in the first two subharmonic resonances.
应用Liapunov线性化稳定性理论,导出次谐波共振时零解与非零解的不稳定条件。
4)  3rd super harmonic resonance
3次超谐共振
1.
By means of the method of multiple scales for nonlinear vibrations the approximation solution of 3rd super harmonic resonance of the system was acquired.
为了研究温度场中非线性地基上矩形薄板受简谐激励的3次超谐共振问题,应用弹性力学理论建立其动力学方程,应用Galerkin方法将其转化为非线性振动方程。
5)  3 super-harmonic resonance
3倍超谐波共振
6)  subharmonic resonance
次调和共振,次谐波共振,分谐波共振
补充资料:谐波


谐波
harmonics

  (harmonies)频率为基波频率整数倍的正弦波分量,又称高次谐波。在交流电路中.具有非线性阻抗特性的电气设备(见非线性负荷)向电源反馈高次谐波,导致电力系统电压、电流波形崎变,使电能质盘变坏。近年来,由于电力电子技术的发展,大量换流设备、电子设备等具有非线性阻抗特性的电气设备接人电力系统,造成谐波污染。这些电气设备称之为谐波源,主要有电力机车、电弧炉、整流器、变频器、逆变器、相控调速和调压装置、电焊机、感应加热设备、气体放电灯以及有磁饱和现象的机电设备。 谐波的危害性表现在干扰通信线路,使同步发电机额定输出功率降低,感应电动机功率因数下降、转矩降低、损耗增加,变压器温度升高、效率降低,加速电气设备绝缘介质老化,使用寿命缩短,甚至损坏,控制保护及枪侧装t工作精度、可靠性降低等。 谐波限制标准见供电质童。
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条