1) corrosion stress
腐蚀应力场
1.
The formula to determine corrosion products of steel in reinforced concrete subjected to external DC was presented,the influence of corrosion on stress in concrete was discussed,and a concept of corrosion stress field was proposed.
给出了混凝土中钢筋在外加直流电腐蚀下腐蚀产物的计算公式,探讨了钢筋腐蚀引起的混凝土内部腐蚀应力场,同时分析了混凝土在腐蚀应力作用下发生破裂的最短时间。
2) stress corrosion cracking
应力腐蚀
1.
Role of Hydrogen in Stress Corrosion Cracking of High Strength Pipeline Steel;
氢在高强度管道钢应力腐蚀中的作用
2.
Stress Corrosion Cracking of Pipeline Stell Welded Joints and Defence;
油气管道焊接接头的应力腐蚀及防护
3.
Influence of inhomogeneity on stress corrosion cracking of welded joints;
不均匀性对焊接接头应力腐蚀开裂的影响
3) stress corrosion
应力腐蚀
1.
Study of microstructure,electrical conductivity and stress corrosion resistance of Al-Zn-Mg-Cu alloys;
Al-Zn-Mg-Cu合金组织和电导率及抗应力腐蚀性能研究
2.
Calculation and regression analysis to susceptibilities indexes of stress corrosion cracking for 316L stainless steels;
316L不锈钢应力腐蚀敏感性指数计算与回归分析
3.
Electronic theoretical study of stress corrosion mechanism of Ti metal;
钛金属应力腐蚀机理电子理论研究
4) SCC
应力腐蚀
1.
SCC Caused by H_2S of Main Gas Pipeline;
管道硫化氢应力腐蚀破裂的原因分析
2.
THE CORRESPONDENCE BETWEEN SUSCEPTIBILITY TO SCC OF BRASS AND CORROSION-INDUCED TENSILE STRESS UNDER VARIOUS pH VALUES;
不同pH值下黄铜应力腐蚀敏感性与腐蚀引起拉应力的对应性
3.
STUDY ON SCC PROCESS OF Ti IN METHANOL KCl SOLUTION BY MEANS OF MICRO MULTIPLICATIVE MOIRE INTERFEROMETRY;
云纹干涉反转倍增技术研究Ti的应力腐蚀行为
5) Stress-corrosion
应力腐蚀
1.
The stress-corrosion cracking of stainless steel was caused by Cl~- and Fe~(3+) in the medium.
通过对开裂的螺旋板换热器进行分析检验认为 ,介质中大量的Cl- 和Fe3+ 导致不锈钢发生应力腐蚀开裂是换热器失效的主要原因。
2.
The failure of the bolts was caused by wet H2S stress-corrosion.
5;其断裂的原因是环境中的湿硫化氢应力腐蚀所致。
3.
The stress-corrosion damage of concrete is the coupled action result of stress and corrosion medium, and its study is in exploratory stage.
为全面系统地研究混凝土在应力与腐蚀介质耦合作用下的环境响应,利用专门设计的应力腐蚀加载试验装置,分析了高性能混凝土在三分点加荷与腐蚀溶液同时作用下的性能衰减规律,及各试验结果对应力腐蚀评价指标的敏感性。
6) stress corrosion crack
应力腐蚀
1.
Influence of graphite epoxy composite materials on the stress corrosion cracking of aluminum alloys;
碳纤维环氧复合材料对铝合金应力腐蚀性能的影响
2.
The stress corrosion crack tests of 16MnR steel in anhydrous ammonia service have been done with the T shape wedge opening loading(T-WOL) constant displacement specimens.
采用T形楔形张开加载(T-WOL)恒位移试样,进行16MnR钢在无水液氨环境的应力腐蚀实验。
3.
Results indicate that the H 2S damage of welded pipes shows blister and stress corrosion cracking(SCC) in pipe surface.
结果表明 ,焊管在H2 S介质中的损伤表现为母材表面氢鼓泡及应力腐蚀裂纹 ;随着施加应力的提高及残余应力的增大 ,H2 S腐蚀倾向增大 ;在H2 S介质中和外加应力及残余应力的共同作用下 ,焊管的氢损伤机理既有氢致开裂 ,又有氢致应力腐蚀 ,应力不但促进氢致应力腐蚀 ,同时也促进氢致开裂过程 ;试验结果说明改进焊管焊缝表面质量、降低残余拉应力、控制工作应力是改善和控制焊管H2 S腐蚀的重要措
补充资料：固定应力腐蚀
分子式：
分子量：
CAS号：
性质：见应力腐蚀。
分子量：
CAS号：
性质：见应力腐蚀。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条