说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 压实检测标准
1)  monitor criterion for compression
压实检测标准
2)  examination standard
检测标准
1.
The danger and examination standard of automobile′s contamination are studied,at the same time,can promote the improvement of main measures and methods to resolve the pollution of automobile,which have important value for reducing automobile gas pollution and relieving environmental pollution attribute to automobile gas.
对汽车排放有害物质的危害和检测标准进行深入分析,可以有效促进汽车排放污染主要技术措施和方法的不断改善,对减少汽车尾气污染物的排放、缓解由于汽车尾气导致的环境污染具有重要意义。
3)  testing standard
检测标准
1.
The anticorrosion coating designs,procedures,technical requirements,quality control system and testing standard are introduced in this paper.
着重介绍防腐涂层的设计方案、施工工艺、技术要求、质量保证体系和检测标准等。
2.
This paper introduces the types and fire-resisting mechanisms of fire-proofing coatings; shows its testing standard and method; summarizes the current situation both at home and abroad of searching and applying fire-proofing coatings ,especially in several aspects of constituting dilative fire-proofing coatings: base material、deaquation reagent、 coking reagent、bubbling reagent and additives etc.
介绍了防火涂料的种类和防火机理;说明了防火涂料性能的检测标准及方法;着重从膨胀型防火涂料的基料、脱水剂、碳化剂、发泡剂和助剂等几个方面概述了国内外防火涂料的研究现状。
3.
Introducing into the principle of information index,implementing the network information system management for the testing standard of the department.
引进信息检索原理,将本部门的检测标准进行网络信息系统管理。
4)  Compaction standard
压实标准
1.
Study on compaction standard of subgrade with bearing sand silt of low liquid limit;
含砂低液限粉土路基压实标准的探讨
2.
The author analyzes the imperfection of the testing standard of the fill compaction at present,systematically summarizes the engineering properties of the filling,puts forward the compaction standard and the detection method combined with the engineering practice based on the extensive experiments and research of the various types of the soil,to accumulate the engineering experience.
分析了目前填土压实检测标准的不完善性,系统地总结了各类填土的工程性质,结合工程实践,在对各类土进行大量试验研究的基础上,提出了相应的压实标准和与之相应的检测方法,从而积累工程经验。
3.
By analyzing the stress distribution conditions under subgrade,the paper proposed different compaction standards of quality control.
通过分析路基下应力的分布情况,提出了针对不同的受力要求,在质量控制上采用不同的压实标准。
5)  compaction criteria
压实标准
1.
The object of this paper is to determine the compaction criteria of loess subgrade.
为从理论上确定黄土路基的压实标准,首先确定以路表弯沉和路基顶面压应变作为受路基压实标准影响的沥青路面设计指标,根据半刚性基层沥青路面力学分析获得的路基内部压应变分布以及在试验路测得的行车荷载作用下路基内部的压应力分布将整个路基分为距路基顶面0~80 cm的路床和路床下路基两部分,通过分析路基回弹模量对于路面结构层厚度的影响确定了路基不同深度处的回弹模量要求,并试验研究了压实度对于压实黄土的回弹模量和浸水后附加压缩变形的影响。
6)  Compaction measurement
压实度检测
补充资料:德国国家标准(见德国标准化学会、德国标准体系)


德国国家标准(见德国标准化学会、德国标准体系)
National Standards of Germany: see Deutsches Institut für Normung, DIN;standards system of Germany

  Oeguo Guol心日icozhun德国国家标准(Natio.吐S加Ln山切曲of Gen”旧ny)见德国标准化学会;德国标准体系。
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条