1) thermal ignition temperature
热点火温度
2) ignition temperature
点火温度
1.
According to the results of the experiments,the formation ignition temperature of Zheng-408 was precisely confirmed at 365 ℃ to 375 ℃.
结果表明,郑408块油藏点火温度为365~375℃,火烧前缘推进速度与注气强度呈正相关,在充分注气燃烧条件下,地层不会出现结焦现象;火烧之后岩石矿物组分改变有利于储层渗透性能的改善,但变化不大。
2.
The influences of various ignition temperatures and environmental temperatures on the synthesis were examined.
考察了不同点火温度以及不同环境温度的影响 ,并与硝酸盐直接煅烧分解进行了比较 。
3.
The design idea of optimization control of ignition temperature system for LAIGANG 265m2 sintering machine and its composition were presented in this paper.
介绍了莱钢烧结厂265m烧结机点火温度优化控制系统的控制思想及控制系统的构成。
3) hot-spot temperature
热点温度
1.
Dynamic modelling of hot-spot temperature in oil-immersed power transformers;
油浸式大型变压器热点温度的动态模型
2.
The hot-spot temperature was reduced due to a lot of arch drips appear in glass .
由于玻璃板中出现大量的碹滴,我们采取了降低热点温度的方法使碹滴问题得到了解决,但同于热点温度的降低,玻璃的微观质量比降温前下降了很多;针对这一点我们通过调整下班组成和配合料质量,达到改善和提高玻璃质量的目的。
3.
Method of loop up load table and hot-spot temperature calculation are applied to assess the overload capacity of large oil-immersed power transformer under the conditions of normal periodic overload and accident overload,and countermeasure against risk of accident ov.
并应用查负载表法和热点温度计算法评估大型油浸式电力变压器正常周期性过负荷和事故过负荷能力,给出了500 kV大型油浸式电力变压器事故过负荷运行风险的应对措施。
4) hot spot temperature
热点温度
1.
The inordinate temperature rise in oil-immersed transformers is featured by hot spot temperature(HST).
变压器在温升过程中温度分布不均,热点温度是其中具有代表性的确定变压器最优化负载的重要参数。
5) thermal ignition temperature
热着火温度
6) igniting point
着火温度，着火点
补充资料：负温度系数热敏电阻陶瓷(见热敏陶瓷)
负温度系数热敏电阻陶瓷(见热敏陶瓷)
thermo-sensitive ceramics with negative temperature coefficient
负温度系数热敏电阻陶瓷thermo一sensitiveeeramies with negative temperature eoeffieient在某一特定温度范围，电阻率随温度的升高而明显减小的热敏陶瓷。简称NTC陶瓷。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条