1) number of extruding operations
挤压道数
1.
The number of extruding operations, the extruding forces and the width of indent were determined.
对φ28mm的20MnSi钢筋分别进行了挤压接头的静载性能试验和疲劳性能试验,优化了挤压参数,确定了挤压道数、挤压力和压痕宽度。
2) squeeze-pass
挤压道次
3) extruding parameter
挤压参数
4) extruding coefficient
挤压系数
1.
For shunting combination mold with small-size,thin-wall,complex cross section and large extruding coefficient,the design project and principle,design key points and its applicable range are introduced.
介绍了小型、薄壁、复杂截面且挤压系数较大的分流组合模的设计方案及其设计原理、设计要点和适用范围。
5) extrusion index
挤压指数
1.
Adopting homogenous experimental design and applying the response surface method(RSM),the effects of corn variety,screw speed and water content on radial expansion ratio and extrusion index were studied,and the quadratic polynomial mathematical models of expansion ratio and extrusion index were constructed.
采用均匀试验设计方法,应用响应面(RSM)分析了玉米品种、螺杆转速和物料水分含量对膨化率和挤压指数的影响,并建立了膨化率和挤压指数的二次多项式数学模型。
补充资料：冲击挤压(见冷挤压)
冲击挤压(见冷挤压)
impact extrusion
ehongji jiya冲击挤压(impaet extrusion)见冷挤压。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条