1) multi-angular channel
多弯角通道
2) equal channel angular pressing
等通道弯角挤压
1.
Buck ultra-fine grained materials(submicrostructured or nanostructured materials) could be obtained by equal channel angular pressing (ECAP), and it is one of the most promising process for the industrialization.
等通道弯角挤压(ECAP)过程是目前制备块状超细晶粒材料(亚微米或纳米微观结构材料)最具工业前景的工艺之一,研究ECAP变形机理从而开发出具有工程化和商品化价值的工艺具有十分重要的意义。
3) rectangular bend tunnel
直角转弯通道
4) multi channels synchro
多通道自整角机
1.
A kind of Signal detection and alarm system of multi channels synchro based on MCS 51 is introduced in this paper, also the hardware and software of this system are given.
介绍一种基于MCS 5 1单片机的多通道自整角机信号检测告警系统 ,给出了系统的硬件组成和软件流程
5) Square bend
直角弯道
6) Multi-bends
多弯角
1.
With a typical wide plate with multi-bends as the subject, in this paper the thickness variation of the simultaneous forming for the sheet metal with multi-bends have been studied through theoretical calculation analysis, computer numerical simulation as well as the physical experiments, and the pattern of metal flow in the course of forming process has been analyzed either.
本研究以典型的多弯角零件为研究对象,分别用理论计算分析、计算机数值模拟以及物理实验的方法研究了多弯角板料同时成形的变形特性,尤其注重了板料弯曲过程中常见的减薄、伸长等现象的研究。
补充资料：长春冷弯型钢总厂生产的异形冷弯型钢
长春冷弯型钢总厂生产的异形冷弯型钢
长春冷弯型钢总厂生产的异形冷弯型钢
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条