1) opto-electronic integrated circuit(OEIC)
精确测试
2) accurate
精确
1.
An intelligent water meter measured accurately with single chip microcomputer;
用单片机实现精确计量的智能水表
2.
Four bar,multi bar linkages and compound mechanisms can realize given transmitting rate accurately only on a few points,on other points approximately.
提出用具有一个受控原动件的平面五杆机构在任意多的点位上精确实现给定传动比,研究了相应的数学模型建立方法、机构综合方法,并开发了计算机软件。
3.
This article based on programming elaborates the key technique in the procedure of accurate orientation printing.
精确定位打印在各行各业都有广泛应用,本文以delphi为编程环境,详细阐述了精确定位打印程序及关键性技术。
3) precision
精确
1.
The ambiguity and precision of buildings’interior space;
论建筑室内空间的模糊性与精确化
2.
Tree crown recognition and precision toward-target pesticide application;
树形识别与精确对靶施药的模拟研究
3.
Precision and Imprecision Phenomena in English and Chinese Languages and Cultures, and the Related TEFL;
汉英语言文化中的模糊、精确现象与英语教学
4) Precise
精确
1.
With different sensors, this controller, whose advantage are guicker response, less overshoot and more precise, controls different objects’ temperature, flow, liquid level, and rotate velocity.
它的优点是响应快,超调量少而且更精确。
2.
Combined with the engineering and theoretical derivation, an precise and high PSRR bandgap voltage reference in BiCMOS process is designed in this article.
本文从基本工作原理出发,结合实际应用与理论推导,给出一款基于BiCMOS工艺的精确、高PSRR的带隙基准电路的设计。
3.
The difference of actual intent degree in criminal justice should be considered,for it is necessary to achieve justice precise.
直接故意的程度差别应当在刑事司法中有所考虑,这是实现量刑精确的要求。
5) Accuracy
精确
1.
Fuzzy and Accuracy in Translation;
浅谈“模糊”与“精确”
2.
This article discusses language fuzziness and accuracy.
本文探讨了语言的模糊与精确,探究了模糊语言存在的根源,并分析了模糊语言在交际中的六个特征,即含蓄性、简约性、包孕性、概括性、动态性、灵活性。
3.
Wang Guowei s idea on translation can be summarized as follows: "faithful" to the original text; the "accuracy" of the concept; the maintenance of the "original spirit"; the best possible "comprehensibility".
王国维的译论可概括为:"忠于"原文、概念"精确"、保持"神韵"、力求"易解",强调译者理解原语的能力、深厚的译入语素养、"历史之见地"。
6) precision
精确度
1.
Precision of the measurement of body composition using dual-energy X-ray absorptiometry;
双能X线吸收法测量身体成份精确度的研究
2.
Improving the precision of Hall transducer;
提高霍尔传感器精确度的研究
3.
Experimental precision and variety comparison precision in wheat regional trials;
小麦品种区域试验精确度及精度分析
参考词条
补充资料:测试结果可接受性的检查和最终测试结果的确定
测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result
C凡(3)二3.3d,时,取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。,为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac,ptability of test,ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见,当得到一个测试结果时,所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以,对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查,实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的,均可接受。比如,在重复性条件下,所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值,则认为两个结果是一致的,均可接受;如果两个侧试结果的绝对差超过r,则认为它们是不一致的,必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989),在重复性条件下,如果两个测试结果的绝对差不超过r的值,可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较低,须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c,瓜(4)二3.6a,时,取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较高时,只须再作一次测试。当3个结果的极差不超过相应的临界极差
说明:补充资料仅用于学习参考,请勿用于其它任何用途。