1) Open architecture software CNC system
开放式软数控系统
3) Open NC System
开放式数控系统
1.
Research on the Simulation System Based on Virtual DSP for Machining of Open NC System;
基于虚拟DSP的开放式数控系统加工仿真研究
2.
Study on open NC system based on motion controller;
基于运动控制器的开放式数控系统研究应用
3.
High-Speed Communication of PLC and NC in Open NC System;
开放式数控系统中PLC与NC的高速通讯
4) open CNC system
开放式数控系统
1.
Development of open CNC system software;
开放式数控系统软件的开发
2.
Open CNC system of water jet cutting machine based on PMAC;
基于PMAC的水喷射加工机床开放式数控系统的开发研究
3.
The application and research of NC inserting PC open CNC system;
NC嵌入PC型开放式数控系统的研究和应用
5) open architecture CNC system
开放式数控系统
1.
Developing WDM driver in the open architecture CNC system based on Windows 2000;
基于Windows 2000的开放式数控系统中WDM驱动程序的开发
2.
In this paper, the characteristics of an open architecture CNC system based on COM is researched, The paper develops the special bending NC system based on COM .
分析了基于COM技术的开放式数控系统的特点,将COM技术用于卷板数控系统,使用多轴控制器和工业控制计算机,用模块和组件对它的硬件和软件设计作了详细的论述,完成卷板数控系统实时多任务的要求,使系统具有开放性,并应用于工程实践。
3.
Open architecture CNC system satisfies the development demand of modern technology, The research purpose of open C.
开放式数控系统的提出适应了现代技术不断发展的需要，其研究目的是解决市场变化频繁的需求与控制系统专一、框架结构固定之间的矛盾，从而建立一个统一的可重构的系统平台，极大地增强数控控制系统的柔性和适应性。
6) open-architecture CNC system
开放式数控系统
1.
The development of device driver in open-architecture CNC system based on Windows CE;
基于Windows CE的开放式数控系统设备驱动程序开发
2.
KT600 Open-architecture CNC System Based on VersioBUS;
KT600——基于光纤伺服总线的开放式数控系统
3.
Key Techniques Research on Windows CE Based Open-Architecture CNC System;
基于Windows CE的开放式数控系统关键技术研究
补充资料：循环系统的进化昆虫的开放式循环系统
李瑞端绘
[图]
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条