3) Taguchi Design of Experiment
Taguchi试验设计
1.
The simulating result was analyzed and injection process parameters were optimized, and characteristics of optimization of process parameters based on Taguchi Design of Experiment and Uniform Design of Experiment were compared.
基于Taguchi试验设计和均匀试验设计(UDE)方法,应用Moldflow对注塑过程进行模拟,对模拟结果分析处理,优化注塑工艺参数,并分析比较了Taguchi试验设计和UDE方法应用于注塑工艺优化的特点。
4) Taguchi orthogonal experimental technology
Taguchi正交试验技术
5) Taguchi method
Taguchi法
1.
The Taguchi method was used to determine the optimum conditions and.
采用三个控制因素(硅土粉含量、炭纤维含量及处理温度),应用Taguchi法确定最佳条件并减少实验次数,采用方差(Anova)法确定主要实验参数与轻量混凝土力学性能的基准。
2.
Warpage amount as a quality index was obtained by using Taguchi method in which forming conditions like melt temperature,mould temperature,packing pressure,pressure holding times and cooling times act as influencing factors.
以翘曲变形量作为质量指标,采用多因素Taguchi法,获得了塑料在熔料温度、模具温度、保压压力、保压时间、冷却时间五因素四水平下成型塑件的翘曲变形量。
6) Taguchi design method
taguchi设计法
1.
In order to eliminate the interaction of different factors,Taguchi design method is introduced into optimizing the synthesis conditions of the ceria-zircon solid solution on the basis of single factor including Ce/Zr,pH,reaction temperature,reaction time and the amount of surfactant.
为了消除各个因素之间的交互作用,在单一因素考察的基础上,引入taguchi设计法综合考察pH、Ce/Zr、老化温度、老化时间和表面活性剂加量等因素对固溶体结构的影响。
补充资料：保险商实验室安全标准(见保险商实验室)
保险商实验室安全标准(见保险商实验室)
safety standards of UL: see Underwriters Laboratories; UL
Baoxianshang Sh啊nshi anquan bicozhun保险商实验室安全标准(saJ七ty stand助dsofUL)见保险商实脸室。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条