1) Cross-section
[英]['krɔ:s'sekʃən, 'krɔs-] [美]['krɔs'sɛkʃən, 'krɑs-]
平茬断面
1.
Research on Establishment the Quality Evaluation Indicator System for Cross-section of Caragana;
柠条平茬断面质量评价指标体系的研究
2) cutting
[英]['kʌtɪŋ] [美]['kʌtɪŋ]
平茬
1.
Thus,the experiment of cutting was carried out for Calligonum arborescens(7a),and then its benefit was analyzed based on the monitoring data in middle part of shelterbelt along the Tarim Desert for long time.
在极端生境胁迫下,乔木状沙拐枣种植7-8年后即出现长势减弱,自然枯死等现象,本文对7a生乔木状沙拐枣植株进行了人工平茬试验,并对其平茬效益做了分析,得出以下结论:(1)乔木状沙拐枣的再生能力较强,第一次平茬后新生枝株高,冠幅,地径等迅速增长,且经过第二次平茬后仍能保持良好的生长状态,生物效益显著。
2.
Cutting could not only rejuvenate the plants, but also increase the yield and ratio of edible parts (leaves and tender stems).
探讨了3种岩黄芪属植物平茬与未平茬植株的生物学性状。
3.
According to the degradation reasons of Nitraria shrub and by the two measures of manual rainfall and cutting,the growth\,biolmass\,species diversity and soil moisture content were analyzed.
本文针对绿洲边缘天然白刺灌丛植被退化发生机制 ,采取平茬和人工降雨两种措施 ,从白刺灌丛的生长量、生物量、物种多样性以及沙丘内部水分变化量等方面入手 ,对白刺灌丛的复壮进行了初步的研究。
3) stump
[英][stʌmp] [美][stʌmp]
平茬
1.
In the meantime,the rejuve-nation measures of stumping the wind protection & sand fixing forests of 4 years-old Calligonum rubicundunma in different season and with different stubble height were also studied in this paper.
在春季和秋季(雨季)采用红皮沙拐枣实生苗和插穗扦插造林,研究造林成活率和保存率;同时将4年生红皮沙拐枣防风固沙林采用不同季节和不同留茬高度平茬措施复壮。
2.
The experiment of stumping of Hedysarum scoparium forest was carried out in Yellow River Divert-ing Irrigation Area.
通过对引黄灌区沙地花棒林进行不同留茬高度的平茬试验,其新萌发枝条数和生长量有所不同:在新萌发枝条数目上,留茬高度5cm和10cm时较高,2cm和20cm较低;新生枝条生长过程中,其生长量与留茬高度成负相关关系。
3.
The optimum time of stumping is in the middle and last ten days of April.
平茬对恢复更新腾格里沙漠南缘沙生灌木沙拐枣、沙木蓼和花棒,提高其生长量具有明显的效果,对毛条的恢复有效果,但不十分明显。
4) thin plate section
平板断面
1.
Based on the analytical method (2d-3DOF method) for two-dimensional three degrees of freedom coupling flutter, the flutter-driving mechanism and flutter modality of the classical coupled bending-torsional flutter phenomenon about thin plate sections were investigated.
基于二维三自由度耦合颤振分析方法,对平板断面经典扭弯耦合颤振的颤振驱动机理和颤振形态进行了深入研究。
5) average cross-section
平均断面
1.
Combining the practical work experience, the paper points out the shortcoming of average cross-section method in computing earth and rockfill volume, and presents a new method--change average cross-section method.
结合实际工作经验,指出平均断面法计算土石方工程量的不足,提出改进方法——变更平均断面法。
6) plane section
平断面
1.
Using this system,the processing parts for inner work can receive the data gathered from outer work and aerial survey,and the plane section or the hydrology section drawing can be created automatically.
内业处理部分能够接收外业、航测等采集的数据,自动生成平断面图或水文断面图,实现测绘设计一体化。
补充资料:异形断面钢材(见异形断面型材)
异形断面钢材(见异形断面型材)
special section steel
,一、u以uu、’“飞豆on gQngC01异形断面钢材(speeial Seetion steel)见异形断面型材。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条