1) lean premixed combustion
低氧预混燃烧
2) low-temperature premixed combustion
低温预混合燃烧
1.
The low-temperature premixed combustion, which can achieve this goal, has increasingly drawn the interest of researchers in the global.
低温预混合燃烧就是人们所希望的一种新的燃烧方式,它能够同时大幅度降低柴油机的NOx和碳烟颗粒排放。
3) premixed combustion
预混燃烧
1.
Propagation of premixed combustion wave of methane/air in packed bed;
自由堆积多孔介质内预混燃烧火焰传播
2.
Experimental research on gas/solid temperature distribution in porous media premixed combustion;
多孔介质预混燃烧气固温度分布特性试验研究
3.
Numerical Simulation on the Flashback Character for Lean Premixed Combustion;
贫燃料预混燃烧回火特性数值模拟
4) pre-mixed combustion
预混燃烧
1.
Based on k-ε turbulence model and Stretch-cut-and-slide pre-mixed combustion model, three dimensional distribution of pre-mixed combustion flame in the space with obstacle is simulated numerically.
利用k-ε湍流模型和拉切滑(SCASM)预混燃烧模型,对障碍物场中预混燃烧火焰进行了三维空间数值模拟。
5) low oxygen combustion
低氧燃烧
1.
The influence of low NO X combustion technology,including low oxygen combustion and flue gas recirculation,on the heat transfer performance of ball packed bed regenerator,has been numerically investigated.
通过数值计算 ,研究了低 NOX燃烧技术 ,包括低氧燃烧和烟气再循环 ,对填充球蓄热室传热性能的影响。
2.
Based on the analysis of some kinds of low oxygen combustion,a low oxygen burner with self-circulation of flue gas was developed with contracted/dilated air channels.
在分析了工业中几种低氧燃烧方式的基础上,将收缩-扩张结构用于燃烧器空气通道,开发出了烟气自循环式低氧燃烧器,同时借助FLUENT软件对燃烧器进行了大量数值模拟研究。
6) combustion with low oxygen content
低氧燃烧
1.
Under the combustion with low oxygen content,the conclusion of coal combustion sulfur release is obtained by studying the effect which the changeable oxygen concentration have on the velocity and quality of SO_2、H_2S release,and comparing with the coal combustion sulfur release under the combustion and pyrolysis with air and inert gases.
在低氧燃烧条件下,通过研究变氧浓度对燃煤SO2、H2S析出速率和析出量的影响以及与燃煤分别在空气和惰性气氛下燃烧和热解进行比较,得出了硫析出的规律。
2.
The combustion with low oxygen content is regarded as the core of high temperature air combustion(HTAC)technology.
低氧燃烧是HTAC技术的核心内容 ,其前提是将助燃空气预热到燃料自燃点以上 ,其关键是控制燃烧段的含氧体积浓度 ,使之低于 1 5 % ,甚至 2 %～ 3%。
补充资料：线型低密度聚乙烯/低密度聚乙烯共混物
分子式：
CAS号：
性质：系由线性低密度聚乙烯与低密度聚乙烯组成的共混物，20％的低密度聚乙烯可显著改善线性低密度的加工性能，提高薄膜韧性和透光性，当低密度聚乙烯达50％时，可提高薄膜撕裂强度和断裂伸长率。可通过粒料直接掺混制备。主要用于吹塑农膜、包装膜及挤出包覆电缆。
CAS号：
性质：系由线性低密度聚乙烯与低密度聚乙烯组成的共混物，20％的低密度聚乙烯可显著改善线性低密度的加工性能，提高薄膜韧性和透光性，当低密度聚乙烯达50％时，可提高薄膜撕裂强度和断裂伸长率。可通过粒料直接掺混制备。主要用于吹塑农膜、包装膜及挤出包覆电缆。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条