1) thennocycling test
冷热循环实验
2) thermal cycle experiment
热循环实验
1.
The camera was used for thermal cycle experiments to monitor the average dark output and the nonuniformity of the dark output as functions of temperature.
通过热循环实验,得到了该CMOS相机平均暗输出和暗不一致性随温度的变化曲线,预测其适于在10～25℃的空间温度环境中工作,并可经受-25～60℃的卫星舱内温度变化。
3) thermal cycling test
冷热循环试验
1.
Methods:The adhesive strength and fracture toughness of different adhesive resins, which have different amount of filler contents, were investigated by means of tensile bonding strength and fracture toughness test before and after thermal cycling test.
目的：探讨无机填料对粘接性树脂粘接强度与破坏韧性的影响，同时对４℃和６０℃冷热循环试验的影响进行探讨。
4) thermal cycle
冷热循环
1.
Microscopic analysis on hardened portland cement concrete under thermal cycles;
冷热循环负荷作用下混凝土微观形貌分析
2.
The effects of thermal cycles on the properties of CuZnAl shape memory alloys under different heating temperatures, pre-deformations ε and amounts of complex rare earth mixture added were researched with electronic microscopes.
采用不同的热循环温度、不同的预应变量ε、不同的复合稀土加入量以及透射电镜方法,研究了冷热循环对CuZnAl形状记忆合金的相变温度、记忆性能的影响。
5) thermal cycling
冷热循环
1.
In this paper,the influences of thermal cycling temperature,pre deformation and RE(La+Ce) on the transformation temperature and shape memory effect (SME) of Cu Zn Al shape memory alloys (SMA) were discussed.
结果表明,冷热循环能使合金的相变温度提高5℃-6℃。
2.
AIM:To evaluate the color stability of three bonding agents of porcelain veneers after thermal cycling.
然后用分光光度仪测量冷热循环前后的L*a*b*值,结果采用SPSS 10。
3.
However,there is no such thermal cycling test platform of glass curtain wall in China.
国内尚无可以进行玻璃幕墙冷热循环试验系统与平台,本文介绍了为某建设科学研究院研制开发的玻璃幕墙冷热循环试验系统的原理和功能,重点论述了试验台的结构、流程和控制方法并给出了初次模型试验的结果,结果显示试验系统完全满足美国AAMA501。
6) Thermocycling
[,θə:məu'saikliŋ]
冷热循环
1.
The effect of thermocycling on the microtensile bond strengths of three adhesives to normal vs.caries-affected dentine;
冷热循环对龋坏内层和正常牙本质粘接强度的影响
2.
Effects of thermocycling on nanoleakage within resin-dentin interfaces;
冷热循环对牙本质黏结界面纳米渗漏的影响
3.
By the calculation of air-gap group in the main insulation of stator bars and the analysis of the first current multiplication point in current-voltage curve,the characteristic of air-gap group in both resin-rich coils and VPI coils,the influence of thermocycling on the discharge of air-gap group were discussed.
测量分析了大型水轮发电机定子线棒主绝缘中气隙群放电的理论计算和交流工频I~U曲线的第一电流急增点,研究了相同电压等级的多胶模压和少胶VPI线棒的气隙群特征及冷热循环对气隙群放电的影响。
补充资料：保险商实验室安全标准(见保险商实验室)
保险商实验室安全标准(见保险商实验室)
safety standards of UL: see Underwriters Laboratories; UL
Baoxianshang Sh啊nshi anquan bicozhun保险商实验室安全标准(saJ七ty stand助dsofUL)见保险商实脸室。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条