1) Static difficulty
静态难度
2) dynamic difficulty
动态难度
3) Static stiffness
静态刚度
1.
On the control to static stiffness of tower in tower crane;
塔式起重机静态刚度现状与分析
2.
In the static analysis, study mainly focused on the static stiffness and in obtaining the static stiffness distribution of the whole work piece table.
在静态特性中着重分析了微进给平台的静态刚度,得出整个动平台的工作平面上的刚度分布图。
3.
The Reynolds equation was solved by the finite difference method(FDM) in SOR iteration to obtain the pressure distribution in sealing clearance and the curves of leakage flowrate and static stiffness in different conditions.
为探讨浅槽环瓣型浮动环密封的性能特点,首先分析了密封的结构和工作机理,采用FDM(F in ite D ifferenceMethod)、牛顿超松弛迭代求解Reynolds方程,获得密封间隙的流场压力分布及各种工况条件对泄漏量、静态刚度的影响。
4) Static accuracy
静态精度
1.
This paper makes an introduction to the test contents and algorithms for both static accuracy and dynamic accuracy of NC machine tools,especially those for the positioning accuracy of static accuracy and the process capability of dynamic accuracy.
介绍了数控机床静、动态精度测试的内容和算法，特别是静态精度申的位置度，以及动态精度中的工序能力。
5) static scheduling
静态调度
1.
The static scheduling with "Interrupt Affinity" is adopted to balance the load among processors, and to reduce the cache misses due to .
为此,采用"中断亲和"的静态调度方法来均衡处理器负载,并降低调度引起的高速缓存命中失败率。
2.
On the basis of proceduring job network,this paper proposes a three-layers loads balance model include "overall scheduling-static scheduling-dynamic scheduling".
在可调度的过程化作业网络的基础上提出了"全局调度-静态调度-动态调度"的三层负载平衡调度模型。
3.
In this paper,an novel independent RF configuration is proposed by comparing and analyzing a few currently RF configurations,and the number of register port is reduced and the bypass circuit is simplified by means of static scheduling method.
本文通过对现行采用的几种寄存器文件结构的分析对比,提出了一种新的独立寄存器文件单元结构,即将寄存器文件作为一个流水级单元,并且通过编译器静态调度的方法实现了寄存器文件端口数的减少以及旁路电路的简化。
补充资料：难度海
【难度海】
（譬喻）谓生死海也。生死之海，深广难渡也。六十华严经五曰：“已度难度海。”十住毗婆沙论易行品曰：“乘彼八道船，能度难度海。”
（譬喻）谓生死海也。生死之海，深广难渡也。六十华严经五曰：“已度难度海。”十住毗婆沙论易行品曰：“乘彼八道船，能度难度海。”
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条