1) spatial interpolation
空域插值
2) airspace
空域
1.
Research on partition of blind-chess guiding airspace;
盲棋导航的空域划分研究
2.
The Research on the Method of Airspace Evaluation and System Design;
空域评估方法研究及其系统设计
3.
In this paper,based on many ambiguous and fuzzy factors in airspace cost system of civil aviation,by applying the analytic hierarchy process and the fuzzy decision theory,a method combined the qualitative analysis and the quantitative analysis is put forward.
文章针对民航空域成本系统中所包含的大量不确定和模糊因素,应用层次分析法和模糊决策的基本理论,采用定性和定量相结合的方法,选取具有代表性的系统评价指标,对现行民航空域成本系统进行分析及用户满意度评估,并给出具有理论指导和实际意义的评价结论。
3) spatial domain
空域
1.
Restoration method of blurred image based on regularization in spatial domain;
基于空域正则化的模糊图像复原方法
2.
The Performance on Resolving EM Signals of Joint Spectrum in Polarizational and Spatial Domains;
极化域—空域联合谱分辨力研究
3.
Study of Algorithms of Digital Image Restoration Based on Frequency Domain and Spatial Domain;
基于频域和空域的数字图像复原算法研究
4) spatial
空域
1.
Spatial Error Concealment Using Sub-pixel Edge Detection with Hessian Matrix;
基于Hessian矩阵子像素级边缘检测的空域误码掩盖
2.
This paper presents a new spatial error concealment method based on edge detection.
本文提出了一种新的基于边缘检测的空域错误隐藏方法。
5) spatial domain analysis
空域分析
6) spatial distribution
空域分布
参考词条
补充资料:Bessel插值公式
Bessel插值公式
Bessel interpolation formula
十户,业匕生二匕二上业业二且+ ’7’/“(2陀)! 十户划卫二业三卫上塑二止逛卫业二业且, ‘J’/之(Zn+l)!与Gauss公式(l),(2)相比,Bessel插值公式具有某些优点;特别是,如果在区间的中点,即在点t=1/2上插值,则一切奇数阶差分的系数都等于零.如果把公式(3)右边最后一项略去,则所得到的多项式凡,十1(x0十th)虽然不是一个适当的插值多项式(它仅在Zn个结点xo一伍一 l)h,…,x。十从上等于f(x》,但是给出了比同次插值多项式更好的余项估计(见播值公式(interpolatlon扔皿ula)).例如,如果x二x0十th6(x。,xl),则使用关于结点x0一h,x。,x。十h,x。+Zh写出的最常用的多项式 。;‘x‘、+,、、_一、:,,、。,,},一工{、尸,,,业止卫. 一扒‘。’‘”‘一”/2’了’/’UZ}’了’‘’几得到的余项估计,比关于结点x。一h,x。,x。,h或x。,x。+h,x。+2h写出的插值多项式给出的估计几乎要好8倍.Bessel插值公式{肠份哭1 intellx面位用肠nll山反二e”“ItI℃Pn创扭”“o“”即中叩M扒a} 作为Gauss前位]插值公式与同阶的(j:,us、后“,J括值公式(见‘;auss插值公式(Gauss Interp‘)xa[;、)11 folmtlla))之和的半而得到的公式,旋于结点卜,丫。}h.丫。h,I。·“h,丫川,.丫川,l)/7的Gaus、前向插值公式为:八一点工二戈+111卜 (,,十,帆叮h)州·川、、少不一(l) 刃+口(l、l)叮启) (2,:+1)’关f一结点丫。二戈汁h即关J结点玩,h一、、,、Zh一丫。卜h‘、从曰”!泊,、月h的同阶的Causs后向插值公式为‘·:、‘、r一、·,::、了{卜、业示过· ‘,今、、三性二i上二_上二_塑_业工__妇匕__“__土 /l/2飞,卜, “,‘一”(2) 设 (声扮石‘) 一厂冷二一下一一Bessel插值公式取下列形式([l},口1) BZ十:(一‘.“h)(3) 、一、/:{,一井片/少沪 ’/一{2}’一2’
说明:补充资料仅用于学习参考,请勿用于其它任何用途。