1) Measurement and Analysis Model
度量分析模型
2) the Metrics about Requirement Analysis model
需求分析模型度量
3) Quantitative analysis model
定量分析模型
1.
And then based on the principal component analysis method,the quantitative analysis model was given.
首先从定性的角度进行了项目建设人为因素分析,然后基于主成分分析法,提出定量分析模型,最后以某港岛建设为例进行了实例计算,结果表明,管理风险和合同风险是港岛项目建设的关键,应该给予特别的关注。
2.
In order to take different stocking strategy for different repairable parts, the classification of them was made and the quantitative analysis model was established.
为了对不同的维修配件采取不同的库存控制策略 ,对它们进行了分类 ,建立了库存控制的定量分析模型 ,对它的库存控制策略进行了实证研究 ,获得了满意的结
3.
Intensive land use has been an important necessity in building an economical society,and the quantitative analysis model is the foundation for the evaluation.
通过综述土地集约利用评价中所运用的定量分析模型,针对土地集约利用评价模型存在的不足,提出了相应的改进建议:引入相对集约度和协调度,注重系统协调性和指标均衡性;"同质异量"确定指标合理值;运用GIS技术体现评价的动态性和空间性;借鉴土地分等定级的方法,使评价模型规范化。
4) impulse analysis model
冲量分析模型
1.
According to the shock characteristics between composite ultrasonic linear vibrator and guide slide surface,this paper proposed an impulse analysis model for calculating the friction drive force and friction transfer efficiency of ultrasonic motor.
针对复合材料超声直线电机振动体与导轨表面间存在冲击作用的特点，提出一种冲量分析模型计算电机的摩擦驱动力和摩擦转换效率。
6) cost-volume-profit analysis model
本量利分析模型
1.
The traditional cost-volume-profit analysis model is based on the management profit, and it has not considered the cost of capital, therefore break-even point from it certainly would harms the shareholder wealth, Obtained guarantee profit state by it certainly cannot guarantee increases of the shareholder wealth.
传统的本量利分析模型是基于经营利润,没有考虑资本成本。
补充资料：可公度量和不可公度量
可公度量和不可公度量
ommensulble and incommensuable magnitudes (quantities)
可公度t和不可公度t【~e璐u由lea目in~men-su.ble magultodes(quanti柱es);“洲口Mel娜M毗“”“”-113Mep目M曰e肠eJ皿，一皿曰』 如果两个同类量(例如两个长度或两个面积)具有或不具有公度(common measure，即另一个同类量，所考虑的两个量都是这个量的整数倍)，则相应地称这两个量为可公度量或不可公度量.正方形的边长和对角线，或圆的面积和丫的半径的平方，都是不可公度量的例尹.如果两个量是可公度的，则‘l艺们的比是有理数;相反，不可公度量忿比是无理数、
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条