1) Common-mode feedback circuit
共模反馈电路
2) common-mode feedback resistor
共模反馈电阻
1.
Concerning the teaching of the principle of differential amplifier with single input,equivalent transfor-mation method is always utilized to analyze the function of the common-mode feedback resistor Re.
在单端输入的差动放大电路工作原理教学中,对共模反馈电阻R e的作用,往往采用等效变换法进行分析,如果不注意正确使用分析条件会得出错误的结论,本文从理论和实践上指出了利用这种分析方法分析单端输入差动放大电路的局限性,最后给出了正确的分析方法及结论。
3) Voltage common-mode negative feedback
电压共模负反馈
4) Analog feedback control circuits
模拟反馈电路
5) common-mode feedback
共模反馈
1.
High gain CMOS telescopic operational amplifier with common-mode feedback;
带共模反馈的CMOS套筒式高增益运算放大器
2.
High gain CMOS folded operational amplifier with common-mode feedback;
带共模反馈的CMOS折叠式高增益运算放大器
3.
For a long time switch-capacitor common-mode feedback circuits have been used in fully differential OTA, yet withou sufficient analysis in theory, resulting in unreasonable design.
长期以来,开关电容共模反馈被广泛应用于全差分OTA中,但缺乏足够的理论分析,以至于出现设计的盲目性。
6) CMFB
共模反馈
1.
A New Connection of CMFB Circuit in Fully Differential OPAMP;
全差分运放中共模反馈电路的一种新接法
2.
A new CMFB circuit is used to stabilize the common mode level of the output;Effected measures are used to constrain the wing of the output of the pre.
采用一种新颖的共模反馈电路实现了对输出共模电平的稳定,并采用有效的措施限制了前级放大的差分输出摆幅。
3.
The operational amplifier based on the structure of folded cascade,a continuous time CMFB and a low-voltage and wide output swing bias circuit to obtain a high unity-gain bandwidth,a wide output-voltage swing.
该运放采用了折叠式共源共栅放大结构、连续时间共模反馈电路以及低压宽摆幅偏置电路,以实现在高稳定性下的高增益带宽、大输出摆幅。
补充资料：共模干扰与串模干扰
共模干扰与串模干扰
common-mode interfer-ence and differen-tial-mode interfer-ence
gongmo ganroo yu Chuonmo gonroo共模千扰与串模干扰(eommon一mede inter-ference and differential一mede interferenee)见电力系统调度信息。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条