1) labeled self-complementary graph
标定自补图
1.
The enumeration of labeled self-complementary graphs is a well--knownunsolved problem in LABELED ENUMBERATION THEORY.
标定自补图的计数问题是“组合计数”理论中的著名难题,至今毫无进展。
2) Matrix decision of selfcomplement graph
自补图矩阵判定
3) self-complementary graph
自补图
1.
In this paper,we studied the problem of L(2,1)-labeling on self-complementary graphs and proved that λ(G)≤2Δ for self-complementary graphs.
研究自补图G的L(2,1)-标号问题,证明了自补图的L(2,1)-标号数满足λ(G)≤2Δ。
2.
The(edge) covering number and (edge) independence number of the self-complementary graph are discussed.
主要讨论了自补图的边独立数和边覆盖数，给出了点独立数的严格上、下界： ，其中 是 的点色数，分析并证明了点独立数取得上、下界的自补图的存在性。
4) self complementary graph
自补图
1.
The properties of self complementary graphs were studied.
研究了自补图 Gp 的一些性质 ,提出新的算法 ,得到 3个对角 Ramsey数的新下界 :R( 17,17)≥ 8917,R( 18,18)≥ 110 0 5,R( 19,19)≥ 1788
5) self-complementary
自补图
1.
In this paper, we get the diameter of three kind of self-complementary and then give a necessary and sufficient condition from matrix adjacency when the diameter is 2 or 3.
本文给出了三种类型的自补图关于直径方面的结果,并从自补图的邻接矩阵给出了自补图直径为2或3的一个充要条件。
6) calibration-compensation
标定补偿
1.
According to angular velocity and accelerate error mathematical models of micro inertial measure unit(MIMU),a kind of quick calibration-compensation method called dynamic overturn 6 positions was proposed based on special features of micro electronic mechanical system(MEMS) inertial devices,which only needed one single axis velocity rolling plate(without referring to the north).
根据微机电系统MEMS(Micro Electronic Mechanical System)惯性器件的特点,在建立微惯性测量单元MIMU(Micro Inertial Measurement Unit)角速度及加速度误差数学模型的基础上,提出一种适用于MIMU的、仅采用单轴速率转台(无指北装置)的"动态翻转6位置"快速标定补偿方法。
补充资料：自调自净自度
【自调自净自度】
（术语）同自调项。
（术语）同自调项。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条