1) PHEMA PU
支架/孔隙性
2) growth-framework porosity
生长格架孔隙性
3) overhead pore
架空孔隙
4) porous scaffold
多孔支架
1.
The preparation and characterization of porous scaffold made of nano-hydroxyapatite/chitosan composite for bone tissue engineering;
骨组织工程用纳米羟基磷灰石/壳聚糖多孔支架材料的制备及性能表征
2.
A novel porous scaffold of nano-hydroxyapatite and polyamide6 for tissue engineering was made by a method of phase separation and particle leaching combined(PS/PL),NaCl and alcohol were used as pore forming agent.
以NaCl为致孔剂,采用粒子沥滤-相转移法制备了纳米羟基磷灰石/聚酰胺6(n-HA/PA6)多孔支架材料,用扫描电子显微镜(SEM),X射线衍射(XRD),示差扫描量热仪(DSC)等对其进行表征。
3.
This study is focused on tissue engineering porous scaffolds,especially the measurement of underlying degradation rates.
考察了聚乳酸多孔支架不同温度下的降解行为,提出了一种降解速率的快速外推方法。
5) porous scaffolds
多孔支架
1.
Fabrication and characterization of the porous scaffolds for bone tissue engineering;
骨组织工程多孔支架材料性质及制备技术
2.
Ladder-like and well-interconnected porous scaffolds were fabricated from poly(ether- ester)-poly(butylene terephthalate)-co-poly(cyclohexylene dimethyl terephthalate)-b-poly(ethylene glycol))(PTCG)-dioxane(DO)systems by means of a combination of freeze-drying and thermally induced phase separation(TIPS)technique.
采用热致相分离(TIPS)结合冷冻干燥技术制备了聚醚酯-(聚对苯二甲酸丁二醇酯-co-聚对苯二甲酸环己烷二甲醇酯-b-聚乙二醇)(PTCG)多孔支架,研究了聚合物质量浓度、粗化温度和溶剂组成等相分离参数对多孔支架形貌结构的影响。
3.
The biological performance of the porous scaffolds was assessed by in vitro chondrocyte culture.
采用明胶和氯化钠颗粒作为致孔剂,使用溶剂浇铸/颗粒沥滤法制备了高孔隙率、孔间连通和高机械性能的聚乳酸支架, 采用软骨细胞体外培养研究了这两种多孔支架对细胞生长性能的影响。
补充资料：孔隙性试验
分子式：
CAS号：
性质：又称瓷吸红试验(porcelain absorption rosanline test)。利用毛细作用鉴定瓷件是否生烧的试验。将瓷件试块置于含0.5％品红的酒精溶液中，在压力不低于15MPa条件下维持一段时间，其时间(小时计)与压力的乘积应不小于60，然后将试块取出，冲洗、烘干后观察表面，击碎后检查其断面有无品红渗透现象，从而判定瓷件的烧结程度。
CAS号：
性质：又称瓷吸红试验(porcelain absorption rosanline test)。利用毛细作用鉴定瓷件是否生烧的试验。将瓷件试块置于含0.5％品红的酒精溶液中，在压力不低于15MPa条件下维持一段时间，其时间(小时计)与压力的乘积应不小于60，然后将试块取出，冲洗、烘干后观察表面，击碎后检查其断面有无品红渗透现象，从而判定瓷件的烧结程度。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条