1) Fireball's Temperature
火球温度
2) ignition temperature
着火温度
1.
KCl and NaCl on ignition temperature,combustion characteristics and area of heat liberation of high ash coal (HAC) is investigated by thermogrametric analysis.
用热重分析方法对比研究了Ca(NO_3)_2,KCl和NaCl对高灰分煤(HAC)着火温度、燃烧特性指数和放热面积的影响。
2.
The effect of different catalysts on the slime ignition temperature,burning completely temperature,and area of heating value are compared,The results show that catalysts can decrease the ignition temperature and burning completely temperature,increase the quantity of heat releasing during combustion,and the catalytic effect of the TF catalyst is better than KNO 3 catalyst.
对比研究了硝酸钾催化剂及 TF配方助燃催化剂对兖州煤泥着火温度、燃尽温度和放热面积的影响 。
3.
5% in a slurrying process, the ignition temperature of coal is reduced from 582℃ to 576℃ and the burnout efficiency of fixed carbon is promoted from 91.
用热重法研究了不同条件下电石渣的催化煤燃烧特性,发现电石渣对晋城煤的着火温度和固定碳燃尽率都具有一定的促进作用,而且随添加量的增加助燃作用增强。
3) flame temperature
火焰温度
1.
A novel device for measuring pulse flame temperature and water vapor concentration;
脉冲火焰温度及水蒸气浓度测量装置研究
2.
Research on the data processing method of the luminous flame temperature;
一种测量发光火焰温度的数据处理方法研究
3.
An Improved Two-color Method Measurement System for Local Transient Soot Concentration and Flame Temperature in the Cylinder of Diesel Engines;
柴油机气缸内局部瞬态碳粒浓度、火焰温度改进双色法测量系统
4) tempering temperature
回火温度
1.
Effects of tempering temperature on the microstructures and properties of vessel steel with high strength;
回火温度对高强度容器钢组织结构与性能的影响
2.
Effect of Tempering Temperature on Structure and Mechanical Properties of Steel 30CrMnSiNi2A;
回火温度对30CrMnSiNi2A钢组织和性能的影响
3.
Effect of Tempering Temperature on Microstructure of Steel ZG0Cr13Mn8N;
回火温度对ZG0Cr13Mn8N钢显微组织的影响
5) quenching temperature
淬火温度
1.
The effects of quenching temperatures on wear resistance of 3Cr2W8V steel were studied.
采用销盘式高温磨损试验机对3Cr2W8V钢进行高温磨损试验,研究了淬火温度对3Cr2W8V钢磨损性能的影响,采用SEM、EDS、XRD分析磨损表层成分、形貌和结构,探讨高温磨损机制。
2.
Martensite is getting coarser and the proportion of dislocation to twin is up first and down later with quenching temperature rising.
随淬火温度升高,马氏体逐渐粗化,马氏体亚结构中位错对孪晶的比例先升后降,890℃时获得完全位错亚结构。
3.
Under the condition of water cooling quenching,the influence of quenching temperature on microscopic structure and macroscopic hardness of Fe-B-C casting alloy which contents 0.
在水冷淬火条件下,研究了淬火温度对含0。
6) flue temperature
火道温度
1.
According to multiple-working-conditions characteristics of coke oven combustion process,a multimode fuzzy-expert control method with analysis layer and control layer for flue temperature is presented.
针对焦炉燃烧过程的多工况特征,提出一种具有分析层和控制层的火道温度多模态模糊专家控制方法。
2.
An optimization control method was presented for the flue temperature in multi-operative modes in the coordinating layer and the optimizing control layer for coke oven heating process.
对于焦炉加热这一复杂工业过程,提出一种包括协调层和优化控制层的多工况火道温度优化控制方法。
3.
Therefore, how to determine the right gas flowing rate and flue suction to stabilize the flue temperature and make the coke oven burning in the optimal status is the most cr.
火道温度是影响焦炉燃烧过程的重要参数,如何确定煤气的流量和烟道的吸力,使焦炉处于最优的燃烧状态,是进行焦炉火道温度控制的关键性问题。
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条