1) segment confine
分段约束
2) several high strength rings like a chain
分段约束箍筋
1.
In order to improve the deformability of the members,four specimens of high performance concrete shear wall with several high strength rings like a chain along boundary element in the potential plastic region were designed and the quasi-static tests were carried out according to performance-based seismic design theory.
研究结果表明,三个性能水平对应的层间位移角与构件的损伤程度有较好的相关性,可以用作这种构件的性能指标;根据轴压比和位移延性需求确定的分段约束箍筋数量和范围,可以明显改善高性能混凝土的脆性,使高性能混凝土剪力墙的延性指标达到设计要求。
2.
According to performance-based seismic design theory,six specimens of high performance concrete shear wall with boundary columns and several high strength rings like a chain along boundary element in the potential plastic region were designed and the quasi-static tests were carried out.
研究结果表明,三个性能水平对应的层间位移角与构件的损伤程度有较好的相关性,可以用作这种构件的性能指标;设置端柱并根据轴压比和位移延性需求确定的分段约束箍筋数量和范围,可以明显改善高性能混凝土剪力墙的脆性,使高性能混凝土剪力墙的延性指标达到设计要求。
3) segmented state constraint
分段状态约束
1.
Research on numerical algorithms for nonlinear predictive control problems based on segmented state constraints
分段状态约束非线性预测控制数值算法研究
4) solution constraint
手段约束
1.
First,Since financial crime is a major cause for the creation of NPLs,there is a solution constraint that solely depends on regulatory authority who merely endowed administrative right as the unique way to resolve NPLs.
本文通过对黑河市所辖的北安市农村信用社依靠公安机关打击金融犯罪清收不良贷款的个案分析 ,得出如下三个基本结论 :第一 ,在银行大量的不良贷款中存在着相当比重的金融犯罪 ,而仅仅具备行政权力的金融监管部门是无力解决犯罪问题的 ,因而存在手段约束问题 ;第二 ,单纯依靠加强人民银行监管的办法来降低不良贷款比例不能完全达到预期目的 ,存在着主体错误 ,降低不贷款比例的内因和主体都是金融机构 ;第三 ,因不良贷款中存在着大量的金融犯罪 ,必须扩大解集 ,把司法部门引入不良资产化解进程中。
5) restrained split-flow
约束分流
1.
Numerical simulation of restrained split-flow in upsetting-extrusion forming of cylinder gear;
圆柱齿轮镦挤成形约束分流的数值模拟
6) stream split constraint
分流约束
1.
In this paper a method based on enthalpy intervals of composite curves is presented for area targeting of Heat Exchanger Network in the presence of stream split constraints.
基于组合线能量分区的概念,提出分流约束条件下换热网络的面积目标计算方法。
补充资料：东汉分段锦铜马
东汉分段锦铜马 东汉时期铜制品。1975、1976年，贵州兴仁、兴义东汉墓出土。铜马系分段铸造，装配而成。全马分头、耳、颈、身躯、尾四肢十一段。除两耳外，其余九段皆砂模空心铸造，装配接头为子母口，由十七个销拴固定。两耳及尾铸成子母口投合后，再涂上一种白色粘合料加以固定。从耳至足通高88厘米。昂首翘尾，左前肢提起，张嘴露齿作嘶鸣状。两耳直立，耳内涂朱。辱涂朱，上唇外残留有涂金痕迹，面具涂金。腹部丰满，臀部方圆，长肢，肘腋开豁，方膝，厚蹄，尾打结，这种分段铸造，镶接成形的铜马，在四川也曾出土过，但不多见。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条