1) dry flowablity
干流性
2) dry fluidity
干流动性
1.
Through adjusting and optimizing the production formula and process,the dry fluidity and rheological property of the obtained special PVC resin (with polymerization degree of 700) had approached the actual levels of TK-700 PVC resin produced by Japan Shin-Etsu company.
简述了管件专用聚氯乙烯树脂在上海天原化工有限公司的30m3聚合釜的生产情况,对生产中的配方和工艺进行了调整和优化,生产出聚合度为700的管件专用聚氯乙烯树脂的干流动性和流变性能接近日本信越TK-700聚氯乙烯树脂的实测水平。
3) basic dry lining material
碱性干式自流料
1.
For high-efficiency casting and variety development,silica insulation plate was replaced by basic dry lining material in the working layer of billet caster tundish.
为适应高效连铸和开发新品种的需要,邯钢第三炼钢厂方坯连铸中间包工作层用碱性干式自流料取代了硅质绝热板。
4) Trading interference effect
流动性干扰效应
5) mainstream
[英]['meɪnstri:m] [美]['men'strim]
干流
1.
Analysis and Calculation of Reduced SO_2 Emission Resulting from Hydropower Station Construction on Tangwang River Mainstream
汤旺河干流水电站规划二氧化硫减排量的分析和计算
2.
Base on the analysis of flowing of Mudan River into Songhua River,this paper provides some quantitative relativity of the influence brought by tributaries flowing into mainstreams,and discusses the influence of tributaries flowing into mainstreams in the basis of the hydraulics kinetic Bernoulli equation,presents the laws of the water level variation of mainstreams for different inflow ratio.
以牡丹江入汇松花江为例,利用实测资料对干支流交汇河段进行分析,为支流入汇对干流的影响提供了一些定量关系。
3.
There is no the runoff formation in the mainstream watershed of the Tarim River.
塔里木河干流本身不产生径流 ,历史上曾有九大水系汇入 ,而现今与塔里木河干流有地表水力联系的只有阿克苏河、和田河和开都河—孔雀河三大水系 ,维系其水与生态系统。
6) stem flow
干流
1.
In the paper,the relationship between the canopy interception of Picea schrenkiana,forest canopy peneration,trunk stem flow and rainfall was investigated based on the data of Xinjiang Tianshan Mountain Forest Ecological Observation Station,State Forest Bureau.
基于国家林业局新疆天山森林生态观测站的观测数据,研究了天山云杉林林冠截留、林冠穿透流、树干干流与降雨量的回归关系。
2.
, interception, through fall and stem flow.
植被对降雨的再分配主要有3种形式:截流、透流和干流,其中,只有透流能溅蚀地面。
补充资料：干流动剂、水悬性颗粒剂
分子式：
CAS号：
性质：又称干流动剂、水悬性颗粒剂。入水后，自动崩解，分散成悬浮液。它是在可湿性粉剂和悬浮剂的基础上发展起来的新剂型，它具有分散性好，悬浮率高、稳定性好、使用方便等特点，避开了可湿性粉剂产生粉尘，悬浮剂包装运输不便，贮藏易产生沉淀、结块、流动性差、粘壁等缺点。生产方法有喷雾造粒、悬式造粒、挤压造粒、高强度混合造粒、流化床造粒等。
CAS号：
性质：又称干流动剂、水悬性颗粒剂。入水后，自动崩解，分散成悬浮液。它是在可湿性粉剂和悬浮剂的基础上发展起来的新剂型，它具有分散性好，悬浮率高、稳定性好、使用方便等特点，避开了可湿性粉剂产生粉尘，悬浮剂包装运输不便，贮藏易产生沉淀、结块、流动性差、粘壁等缺点。生产方法有喷雾造粒、悬式造粒、挤压造粒、高强度混合造粒、流化床造粒等。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条