1) Overlap-length
套接长度
2) looper's length
活套长度
3) overcoat length
外套长度
4) compressive shear strength
套接强度
5) lap length
搭接长度
1.
The stitching joint 3D braided composites with various stitching direction,lap length and stitching density were experimentally studied to reveal the effect of stitching parameters on the tensile property.
研究了多种缝合方向、搭接长度和缝合密度对缝合连接三维编织复合材料拉伸性能的影响,并与三维整体编织复合材料的拉伸性能进行对比。
2.
The graph of tensile strength and lap length is presented and a method of defining the relationship of tensile shear strength and lap length is put forward.
为了研究单搭接接头承载能力与搭接长度的定量关系,对不同搭接长度的单搭接接头进行了有限元分析,得到了单搭接接头承载能力与搭接长度的关系曲线图。
3.
Effect of the lap length on stress distribution in weldbonded joints has been analysed numerically using three dimensional elastoplastic finite element method (FEM).
采用三维弹塑性有限元方法，对采用酚醛树脂和丙烯酸酯两种结构胶粘剂的胶焊单搭接头，研究了其搭接长度对接头中应力分布的影响。
6) Contact length
接触长度
1.
The paper discusses the necessity of applying double stepped backup rolls,and describes the methods for calculating the contact length and stepped depth and work roll crown.
提出了接触长度、阶梯深度及工作辊凸度的计算方法。
2.
The contact length,the grinding temperature,and the grinding forces were measured in-process by using Critical Contact State mode,thermocouple method,and 3-axis piezoelectric dynamometer,respectively.
采用临界接触状态技术、热电偶技术和三向压电晶体测力仪分别在线测量了不同磨削工况下砂轮-工件的接触长度、磨削温度和磨削力。
补充资料：口模接套
分子式：
CAS号：
性质：也称模头联结圈或口模接套。安装在挤塑机筒前端的可动部分，用以支承挤出机挤出口模。在挤塑成型中使口模与机筒相连接的接套，以形成内部物料通道。此接套可以拆卸，便于更换口模。
CAS号：
性质：也称模头联结圈或口模接套。安装在挤塑机筒前端的可动部分，用以支承挤出机挤出口模。在挤塑成型中使口模与机筒相连接的接套，以形成内部物料通道。此接套可以拆卸，便于更换口模。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条