1)  SBN:Cr Crystal
SBN:C1晶体
2)  Sb
Sb
1.
Effects of Sb on Microstructure and Mechanical Properties of Mg-4Al-2Si Alloy;
Sb对Mg-4Al-2Si合金显微组织和力学性能的影响
2.
Analysis of properties of Sn-Ag-Cu solder doped with Sb;
掺杂Sb对Sn-Ag-Cu焊料性能的影响
3.
Effects of Sb modification on heat-treated microstructure and mechanical properties of Mg-6A1-1Zn-0.7Si magnesium alloy;
Sb变质对Mg-6A1-1Zn-0.7Si镁合金热处理组织和力学性能的影响
3)  stibium
Sb
1.
After dissolved by nitric acid and hydrochloric acid, several same samples were added into the five element standard solutions increased by concentration degrees,respectively,then the contents of iron,lead,stibium,zinc and nickel were determined successively by fire atomic absorption spectrometry(FAAS).
用HNO3-HCl溶解试样,在几个相同量的试液中,分别加入质量浓度依次递增的5种元素的标准溶液,用火焰原子吸收法连续测定了Fe、Pb、Sb、Zn和Ni的含量,建立了优化的仪器测定条件,并对可能存在的元素进行了干扰试验。
4)  antimony
Sb
1.
7Si magnesium alloy modified by antimony,were investigated.
研究了Sb变质Mg-6Al-1Zn-0。
2.
After dissolved by HCl-HNO_3,samples were added into the nine elements' standard solutions increased by concentration degrees respectively,then the contents of nickel,copper,manganese,iron,lead,antimony,zinc,calcium and magnesium were determined by air-acetylene fire atomic absorption spectrometry (FAAS).
用王水溶解试样,在几个相同量的试液中,分别加入浓度依次递增的9种元素的标准溶液,用空气-乙炔火焰原子吸收法连续测定N i、Cu、Mn、Fe、Pb、Sb、Zn、Ca、Mg的含量。
5)  Sb(Ⅴ)
Sb（Ⅴ）
6)  Sb(Ⅲ)
Sb（Ⅲ）
参考词条
补充资料：晶体管-晶体管逻辑电路
晶体管-晶体管逻辑电路
transistor-transistor logic
    集成电路输入级和输出级全采用晶体管组成的单元门电路。简称TTL电路。它是将二极管-晶体管逻辑电路（DTL）中的二极管，改为使用多发射极晶体管而构成。TTL电路于1962年研制成功，基本门电路的结构和元件参数，经历了3次大的改进。同DTL电路相比，TTL电路速度显著提高，功耗大为降低。仅第一代TTL电路产品，就使开关速度比DTL电路提高5～10倍。采用肖特基二极管的第三代TTL电路，开关时间可缩短到3～5纳秒。绝大部分双极型集成电路，都是TTL电路产品。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。