1)  combined determination
联用测试
2)  Combined use
联用
1.
OBJECTIVE: To analyze the irrationality of combined use of antimicrobials.
目的:探讨抗菌药应用中存在的不合理联用情况。
3)  coupling
联用
1.
On-line Coupling of Capillary Electrophoresis and Chemiluminescence Detection Technique for Pharmaceutical Analysis;
毛细管电泳—化学发光在线联用技术在药物分析中的应用
4)  combined application
联用
1.
The inactivation effects of humic acid and lactose peptone culture solution content are inspected with individual application process of chlorine, chloramines and potassium permanganate, and with combined application process of potassium permanganate with chlorine or chloramines.
观察了水中腐殖酸和乳糖蛋白胨培养液的含量变化对高锰酸钾、氯、氯胺单独处理工艺及高锰酸钾与氯或氯胺联用工艺消毒效果的影响。
2.
Microbial inactivation effects are compared with individual application process of chlorine, chloramines or potassium permanganate, and with combined application process of potassium permanganate with chlorine or chloramines, to investigate more effective pre-oxidants.
针对受污染水pH值的改变会影响许多预氧化药剂微生物灭活效能的问题,考察了不同pH值下KMnO4、Cl2、NH2Cl及KMnO4与Cl2或NH2Cl联用灭活微生物的效能,探讨作用较强的预氧化药剂。
5)  combination
联用
1.
The material of the electrode and its application,the structure of the reactor,and the combination with other methods are(discussed.
本文从电极材料与应用,电极结构及反应器形状,以及与其它处理方法联用等综述了最新研究进展,并在此基础上总结出了电催化氧化技术今后的发展方向。
2.
This work has been carried out to study the combination of microwave irradiation and photo-catalytic method.
本实验将微波诱导催化氧化-光催化氧化联用技术用于染料废水的降解,考察了反应过程中染料脱色率、TOC去除率、pH值以及反应前后高效液相色谱图谱的变化情况。
3.
Comparison studies on the performance of PPC(potassium permanganate composite),O_3,combination of PPC and O_3,combination of PPC and Cl_2 were completed for the removal of turbidity and organic matter on the basis of pilot experiments.
针对某市低温低浊水的特点,通过中试对比研究了高锰酸钾复合剂(PPC)、O_3、PPC与O_3联用、PPC与Cl_2联用等预氧化工艺在除浊、除有机物等方面的效能,为低温低浊水的处理提供了技术依据,结果表明:各预氧化工艺对浊度和有机物的去除均有明显的强化作用,不同预氧化工艺之间除浊效能差别不大,均在97%以上;O_3对有机物的去除率最佳,PPC与Cl_2联合预氧化次之。
6)  Combined
联用
参考词条
补充资料:测试结果可接受性的检查和最终测试结果的确定


测试结果可接受性的检查和最终测试结果的确定
check of the acceptability of test results and determination of the final test result

  C凡(3)二3.3d,时,取此3个结果的平均值作为最终侧试结果;否则取它们的中位数作为最终测试结果。。,为重复性标准差(即在重复性条件下所得侧试结果的标准差)。 在口田T 11792一1989中还对重复性和再现性条件下所得侧试结果可接受性的检查方法和最终测试结果的确定做了详细讨论和规定。(马毅林)ceshi 11叩uo kejieshCxjxing d6 iiancha he zuizhong ceshi】i闪旧de que心ing测试结果可接受性的检查和最终测试结果的确定(checkof山eac,ptability of test,ults助ddsterminationofthefi耐testresult)在商品检验中进行一次测试的情形不多见,当得到一个测试结果时,所得结果不可能直接与给定的重复性标准差作可接受性的检查。对测试结果的准确性有任何疑问时都应再进行一次测试。所以,对两个测试结果进行可接受性的检查是一般的情况。 可接受性的检查,实际上是一种统计检验。任何两个测试结果只要能通过可接受性的统计检验即可认为是一致的,均可接受。比如,在重复性条件下,所得结果之差的绝对值(下称绝对差)不超过相应的重复性限r(见重复性和再现性)的值,则认为两个结果是一致的,均可接受;如果两个侧试结果的绝对差超过r,则认为它们是不一致的,必须增加测试。 按国家标准《测试方法的精密度在重复性或再现性条件下所得测试结果可接受性的检查和最终测试结果的确定》(GBIT 1 1792一1989),在重复性条件下,如果两个测试结果的绝对差不超过r的值,可取两个侧试结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较低,须再做两次测试。当4个结果的极差(即其中的最大值与最小值之差)不超过相应的临界极差c,瓜(4)二3.6a,时,取4个结果的平均值作为最终测试结果。如果两个结果的绝对差超过r的值,并且测试费用较高时,只须再作一次测试。当3个结果的极差不超过相应的临界极差
  
说明:补充资料仅用于学习参考,请勿用于其它任何用途。