1)  high toughness ductile iron
高韧性球铁
1.
The influence of process factors on the elongation of as-cast high toughness ductile iron was given in the paper, such as inoculation the C, Si contents, and so on .
本文针对生产实际中铸态高韧性球铁冷却壁铸件存在带缩孔的气孔和氧化铁渣壳两类主要缺陷进行了研究,分析了其形成原因,并提出了相应的改进措施。
2)  As-cast high toughness ductile iron
铸态高韧性球铁
3)  high toughness
高韧
4)  ultrahigh-ductility
超高韧
1.
Mechanical properties of 7055 ultrahigh-strength and ultrahigh-ductility aluminum alloy;
7055超高强、超高韧铝合金力学性能分析
2.
Study of heat treatment scheme of ultrahigh-strength,ultrahigh-ductility aluminum alloy;
超高强超高韧铝合金的热处理工艺研究
5)  high toughness
高韧性
1.
Composition、 mechanical properties and wear-resistance of Zn base alloy with high toughness;
高韧性锌基合金的成分、性能及耐磨性
2.
Bainite alloy steel rail and fork-rail with high strength and high toughness of which tensile strength in hot-rolled condition can reach up to 1250 MPa,25% higher than that of U75V,and impact toughness of rail waist is above 30 J/cm2,3 times higher than that of U75V.
采用合金化方法生产的高强度高韧性贝氏体钢轨及道岔,其热轧态抗拉强度大于1 250 MPa,比U75V提高25%;轨腰冲击韧性大于30 J/cm2,比U75V提高3倍以上。
3.
However it was discovered after analyzing the properties measurement results obtained in the production of high toughness ADI that,with increasing of their tensile strength from 908MPa to 1054MPa,the elongation,impact toughness,yield strength and hardness of alloyed high toughness ADI castings did not change such obviously as f.
对高韧性等淬球铁铸件的生产检测结果进行了分析,发现合金化的高韧性等淬球铁铸件的力学性能之间的关系与一般非合金化等淬球铁铸件不同,其伸长率、冲击韧度、屈服强度、硬度在一定范围内随抗拉强度的提高改变不大。
6)  high strength
高强高韧
参考词条
补充资料:六(氰基-C)高铁酸铁(3+)铵盐(4-)(1:1:1)
CAS:25869-00-5
分子式:C6FeN6·Fe·H4N
分子质量:285.83

中文名称:六(氰基-C)高铁酸铁(3+)铵盐(4-)(1:1:1);染料索引颜料蓝27

英文名称:hexakis(cyano-C)-, ammonium iron(3+) (1:1:1), (OC-6-11)-Ferrate(4-)

hexacyano-ferrate(4 - ammonium iron(3+); afcf

ammonium iron hexacyanoferrate; ammonium-ferric-cyano-ferrate(ii)

ammonium-ferric-ferrocyanide
说明:补充资料仅用于学习参考,请勿用于其它任何用途。