1) absorption salt ratio
吸盐水率
2) saline solution absorption
吸盐水倍率
1.
Water absorption, saline solution absorption and breaking strength were improved by up to 35.
14％,吸盐水倍率最高可增加54。
3) water absorption
吸水率
1.
Prediction of water absorption of modification polyvinyl alcohol using BP Neural network;
BP神经网络方法预测改性聚乙烯醇的吸水率
2.
Effect of pre-wetted shale ceramsite with low water absorption on performances of high-strength lightweight aggregate concrete
低吸水率页岩陶粒预湿处理对高强轻集料混凝土性能的影响
3.
Influence of compound additives on water absorption of paste
复合添加剂对面团吸水率的影响
4) absorption
[英][əb'sɔ:pʃn] [美][əb'sɔrpʃən]
吸水率
1.
Particular attention was paid to their water absorption、apparent density and index of crushing.
本文着重研究了四种不同类型的再生混凝土粗骨料的吸水率、表观密度和压碎指标,实验发现再生混凝土粗骨料的这些性能除受到原生混凝土强度影响外,还跟原生混凝土粗骨料级配密切相关。
2.
Compared with PA6/SEBS, the mechanical properties of PA6/SEBS/PP-g-MAH, such as tensile strength, flexural strength and impact strength have greatly improved, its absorption of water have reduced.
用双螺杆挤出机对PA6用SEBS和SEBS/PP-g-MAH进行共混改性,PA6/SEBS/PP-g-MAH比PA6/SEBS的力学性能如拉伸强度、弯曲强度和冲击强度都有不同程度的提高;PA6/SEBS/PP-g-MAH比PA6/SEBS、PA6的吸水率有较大幅度降低;用扫描电镜(SEM)研究了PA6/SEBS/PP-g-MAH和PA6/SEBS样品的冲击断面,PA6/SEBS/PP-g-MAH中SEBS分散相粒子半径远比PA6/SEBS中SEBS分散相粒子半径小和均匀,这表明PA6/SEBS/PP-g-MAH改性后的PA6与SEBS的相容性有很大的改善。
3.
In accordance with deformation of polished tiles after polishing in many plants,chemical composition of its green body was analyzed,absorption of the polished tiles was tested and its microstructure was also observed by the means of SEM in this article.
针对目前全国较多抛光砖生产企业中存在的大规格抛光砖抛后变形的问题 ,本文对抛光砖的坯料及瓷坯分别做了化学成分分析和吸水率测试 ,并利用扫描电镜对瓷坯进行了显微分析。
5) water absorbency
吸水率
1.
The connection between water absorbency y of copolymer film and Cobb Value x of paper sheet was researched with styrene based copolymer applied to paper as a surface sizing agent.
探讨了苯乙烯共聚物表面施胶剂成膜吸水率x与施胶纸张Cobb值y之间的关系。
2.
The effects of cross-linking agent,initiator and potassium hydroxide contents on water absorbency are studied.
以腐植酸与丙烯酸聚合制备了高吸水性树脂,讨论了交联剂、引发剂以及KOH用量对聚丙烯酸与腐植酸高吸水性树脂吸水率的影响,结果显示在n(MBA)∶n(AA)=0。
3.
By graft polymerization reaction between acrylic acid and sericite ult rafine powder, the superabsorbent composite with water absorbency 1100 times was synthesized.
通过丙烯酸与绢云母超细粉的接枝共聚 ,制备出吸水率为 1 1 0 0倍的超吸水性复合材料。
6) water absorbency
吸水倍率
1.
The effects of crosslinker,initiator,neutralizaiton degree,reaction temperature,expanded vermiculite and mass ratio of monomers on water absorbency are researched.
考察了交联剂用量、引发剂用量、单体浓度、中和度、反应温度、膨胀蛭石含量及单体质量比对吸水倍率的影响,试验结果表明:当膨胀蛭石含量为20wt%时,交联剂用量为0。
2.
In this paper,the effects of valence and kind of various metal ions and pH values of the external solutions on water absorbency of the polyacrylamide/attapulgite superabsorbent composite were studied systematically.
系统考察了金属离子的价态、种类以及溶液的pH值对聚丙烯酰胺/凹凸棒粘土复合高吸水性树脂吸水倍率的影响。
3.
Factors such as molecular weight, kind of crosslinking agent,amount of crosslinking agent,absorbing temperature and absorbing time affecting on water absorbency were studied.
考察了原料分子量、交联剂种类、交联剂用量、吸水温度以及吸水时间等对树脂吸水倍率的影响。
补充资料：用盐水选树种可提高出芽率
用盐水选树种可提高树木种子的发芽率已在实践中证实。其方法是取50公斤清水加4公斤~5公斤清盐，搅动使其溶化，捞去浮在水面上的杂物，然后将树种到入盐水中（使水面高于种子即可），搅动后去除劣种，再把种子捞入清水中洗三四次，晾干后即可下种。这种方法可提高种子出芽率15%。应该注意，浸过种子的盐水不可乱倒。——摘录自《福建林业》99.11期
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条