1) Clearance adjustment weld between reinforcements
鸽尾筋间隙调整焊接
2) double dovetail key
双鸽尾筋
1.
It was described that the new technology of assembly on site of stator core wit h f loating double dovetail key and middle clamping bolt,and the determination of lo cate base,the reasonable choice about technique parameter and the measurement of improving core quality were given in this paper.
本文主要论述了具有可浮动双鸽尾筋及穿心螺杆结构的定子铁心工地施工新工艺、定位基准的确定、工艺参数的合理选择以及提高铁心质量的措施等。
4) Gap adjustment
间隙调整
1.
The Application of PLC in Control System of the printing machine for gap adjustment;
PLC在印刷机间隙调整控制系统中的应用
2.
Through continuous exploration and actual operation, a set of normative methods of engine brake gap adjustment applicable for commercial vehicle service stations is summed up .
介绍了一套新型有效的发动机辅助制动装置——发动机制动的结构及工作原理,探讨发动机制动的特点和使用条件,并经过不断摸索和实际操作,总结出一套规范的适用于商用车服务站推广的发动机制动间隙调整方法。
5) adjusting clearance
调整间隙
1.
Effect of Axial sealing was improved by reforming system and scientific adjusting clearance,thus steam turbine can run more safe,reliably and economically.
根据汽轮机轴封泄漏现象,分析轴封故障产生原因,经过改造密封系统和科学调整间隙,从而改善了轴封效果,使汽轮机更加安全可靠、经济地运行。
补充资料：弯曲模的间隙调整装置
图1为弯曲模的间隙调整装置。在下模上开有长方形孔，其一端带有6°斜度。调整块安装在长方形孔内，相应的面也有6°斜度。调正杆头部是一个偏心圆柱体。调正杆旋转，偏心圆柱体带动调整块上、下滑动，由于有6°斜度，造成间隙变化，调整后用螺母锁紧调正杆。
图1 弯曲模的间接调整装置
1-下模 2-调整块 3-调整杆
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条