说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 支护体最小厚度
1)  minimum thickness of support body
支护体最小厚度
2)  minimal protective cover thickness
最小保护层厚度
1.
The influencing factors to minimal concrete protective cover thickness are presented;and the criteria on minimal protective cover thickness are compared in some kinds of codes for concrete structures at home and abroad.
分析了保护层的作用;阐述了影响保护层厚度的因素,比较分析了国内外多个混凝土结构规范对最小保护层厚度的规定;对国内混凝土结构保护层厚度偏小原因进行分析,并给出了具体建议。
3)  minimum wall thickness
墙体最小厚度
4)  support thickness
支护厚度
1.
This article gives the calculation formula on smallest support thickness of soft stratum and large cross-section shaft and tunnel combined with the calculation method of road tunnel ground pressure,and calculates the force of support structure by FLAC3D,at last checks the stability of arch walling.
结合公路隧道地压计算方法提出了煤矿松软地层大断面井巷最小支护厚度计算公式,并通过FLAC3D对支护结构进行了受力数值模拟计算,最后对碹体稳定性进行了验算。
2.
Based on plastoelasticity mechanics and surrounding rock-supporting principle,the stability of shaft was analyzed,and calculation formula of stress,displacement and support thickness were derived.
根据弹塑性力学及围岩-支护相互作用原理,分析了竖井稳定性,推导了竖井围岩与支护的应力、位移以及支护厚度的计算公式。
5)  the minimum thickness
最小厚度
1.
Thus,an integrated model for the minimum thickness of the intervening liquid film between two contacting fluid particles .
运用平面膜概念将两流体颗粒靠近接触过程与所挟持液膜的排液减薄过程结合起来 ,建立了两流体颗粒接触挟持液膜最小厚度模型 ,并讨论了粒径比、初始相对速度、界面张力和连续相黏度等因素对最小膜厚度的影响 。
6)  minimum thickness
最小厚度
1.
The concept of "minimum thickness" to meet the requirement of filter efficiency is put forward, and the theoretical base for designing ceramic filter element is established.
根据空气动力学捕集理论 ,研究了陶瓷过滤器的过滤机理 ,计算了刚性陶瓷过滤器的过滤流动 ,分析了影响过滤效率的重要因素 ,提出了满足过滤效率要求的“最小厚度”概念 ,为陶瓷过滤器的设计提供了理论依据 。
2.
In this article,the regulation of minimum thickness of completed convex head in GB 150 is discussed.
针对GB 150中关于成形封头最小厚度的规定进行了探讨,分析了在设计图样中标注封头名义厚度和最小厚度的必要性。
3.
In the long-term use of GB 150-1998 "steel pressure vessels" and JB/T 4746-2002 "head for steel pressure vessels",some problems of the acceptance standards of minimum thickness of convex head in the GB 150 were found.
在长期使用GB 150—1998《钢制压力容器》和JB/T 4746—2002《钢制压力容器用封头》标准的过程中,发现标准中关于凸形封头最小厚度的验收规定存在一些问题,易产生误判,造成不必要的损失。
补充资料:最小辐亮度与最小辐照度(见核爆炸火球)


最小辐亮度与最小辐照度(见核爆炸火球)
minimum-brightness and minimum-irradiance

zuixiao fuliangdu yu zuixiaofu乙haodu最小辐亮度与最小辐照度(minimum-brightness and而nimum一irradianee)见核爆炸火球。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条