1)  DOP
溶解总磷
1.
DTP includes DOP and DRP in water body.
水体中的溶解总磷(DTP)包括溶解有机磷(DOP)和溶解活性磷(DRP),目前水体中溶解有机磷(DOP)还不能用钼蓝比色法进行直接测定,必须首先通过某种消化方法使之转化成为溶解活性磷(DRP)后才能进行测定,目前通用的国标消化方法需要在消化釜中高温高压处理,工序复杂,操作周期长,人为因素影响较大,不适合当前环境分析在线化的要求;另外有机磷农药的大量使用正在严重危害着水体环境,而常用的污染物处理方法在处理有机磷农药废水效果上并不理想,可能还会造成二次污染。
2)  dissolve
溶解
1.
Research on temperature which wool keratin was dissolved by mercaptoethanol;
温度对巯基乙醇溶解羊毛角蛋白的影响
2.
Studies of solid phase diffusion-dissolve of Mg powder and Ni powder;
Mg粉和Ni粉固相扩散—溶解的研究
3.
Result shows that the organic releasing film basing on propanone dissolved acrylic resin can give aluminum film or aluminum flake with uniform thickness.
结果发现,通过丙酮溶解丙烯酸树脂基有机释放膜,可获得厚度十分均匀的铝膜或铝鳞片。
3)  solubility
溶解
1.
Effect of alkali on ettringite crystallization and solubility;
碱对钙矾石结晶及溶解性能的影响
2.
Study on the Solubility of Three Kinds of Dental Cements at Early Stage;
3种水门汀早期溶解性比较研究
3.
The effects of temperature, pH, ionic strength and ionic variety on the nitrogen solubility(NSI) of chickpea protein isolate were investigated, and those of pH and ionic strength on emulsifying capacity(EC) and emulsion stability(ES) were also studied.
研究各种外部条件如温度、pH、离子强度、离子种类对鹰嘴豆分离蛋白质溶解性的影响以及pH、离子强度对乳化能力及乳化稳定性的影响。
4)  solution
溶解
1.
Effect of CuAl_2 dissolution during solution treatment on the strength of AlCu-Si alloys after aging;
Al-Cu-Si合金中的CuAl_2相在固溶处理时的溶解对时效后强度的影响
2.
Numerical simulation of hydraulic fracture and solution of rock salt;
岩盐水压致裂溶解的数值模拟
3.
Mass transfer theories and models for pervaporation Ⅱ.Models for membrane sorption and solution;
渗透蒸发传质理论与模型 (Ⅱ )溶解行为
5)  dissolution
溶解
1.
Effect of Matrices on Dissolution of Tungsten Carbide Particulates (WC) in WC Reinforced Iron Base Composite;
基体对WC颗粒在铁基复合材料中溶解的影响
2.
Structural characteristics of cellulose after dissolution and regeneration from the ionic liquid [bmim]Cl;
离子液体中纤维素的溶解及再生特性
3.
The changes of structure and dissolution in DMAc/LiCl of cellulose after pretreated with different methods;
不同预处理条件下纤维素的结构变化及其在DMAc/LiCl中的溶解
6)  Dissolving
溶解
1.
Investigation of swelling-dissolving property of KGM-borate composite gel;
魔芋葡甘聚糖凝胶溶胀—溶解特性研究
2.
Study on the Dissolving Process of High Melting Point Component in TiAl Melt during ISM Process;
ISM过程中高熔点组元在TiAl熔体中溶解过程研究
3.
Cellulose Dissolving technology is a very key point in cellulose fiber producing,the result of cellulose dissolving will effect the quality of spinning solution,solution filtration,fiber forming and final product.
溶解技术是纤维素纤维制造过程中关键的技术,溶解的效果直接影响过滤、纺丝成形和最终产品的质量。
参考词条
补充资料：溶解性总固体
分子式：
CAS号：

性质：又称溶解性总固体。是水质监测项目之一。指在规定的测定条件下，将经过过滤的水样蒸发至干，并烘干至恒重后留下的固体物。水中溶解性因体的主要成分为钙、镁、钠的重碳酸盐、氯化物和硫酸盐等。当其含量过高时可使水产生不良的味道，并能损坏配水管道和设备，降低使用寿命。中国生活饮用水卫生标准规定溶解性总固体含量不得超过1000mg/L，中国地下水质量标准分为五类用水水质，规定了溶解性总固体含量的限值。

说明：补充资料仅用于学习参考，请勿用于其它任何用途。