1) Cr-Ni-Ti ternary system
Cr-Ni-Ti三元系
1.
In thispaper, the isothermal sections of the Cr-Ni-Ti ternary system at 927℃,the Fe-Ti-Si ternary syst.
本文采用上述两种方法研究了Cr-Ni-Ti三元系927℃等温截面相图、Fe-Ti-Si三元系900℃等温截面相图及Co-Fe-Ta三元系1100℃等温截面相图。
2) Ti-Al-Cr ternary system
Ti-Al-Cr三元系
1.
Phase equilibrium relationships and compositions of α2(α)/γ inl the Ti-Al-Cr ternary system between 1000 -1300℃ have been determined by using diffusion couple and EPMA method.
采用扩散偶-电子探针法系统测定了Ti－Al－Cr三元系1000—1300℃的α2（α）／γ相平衡关系和相平衡成分，绘出了Cr含量小于10％（原子分数）范围的Ti－Al-Cr三元系局部等温截面和Ti-Al局部纵截面相图，明确了Cr在α2（α）和γ相中分配比的变化规律，研究结果支持Cr在γ-TiAl相中取代Al的位置，降低γ-TiAl相中Al含量的观点。
3) La-Ni-Cr ternary system
La-Ni-Cr三元系
1.
The 873 K isothermal section of La-Ni-Cr ternary system phase diagram was investigated by X-ray powder diffraction, differential thermal analysis and electron microscopy techniques.
用X射线粉末衍射法,差热分析法和金相分析法测定了La-Ni-Cr三元系600℃等温截面的相关系。
2.
By discussing the 151 alloy samples, the 600C isothermal section of La-Ni-Cr ternary system phase diagram has been confirmed .
通过对151个合金样品进行系统的研究，本文确定了La-Ni-Cr三元系600℃等温截面相图。
4) Ni-Cr-Mo ternary system
Ni-Cr-Mo三元系
1.
The isothermal section of Ni-Cr-Mo ternary system at 1358 K was determined by means of diffusion triple and electron microprobe analysis.
应用三元扩散偶技术测定了Ni-Cr-Mo三元系1358K的等温截面,借助电子探针微区成分分析方法分析了Ni-Cr-Mo三元扩散偶的相区成分,并对其相关系进行了研究。
6) Ni-Cr-Al ternary alloys
Ni-Cr-Al三元合金
补充资料：200t电渣炉生产的180t26Cr2Ni4MoV钢锭
200t电渣炉生产的180t26Cr2Ni4MoV钢锭
200t电渣炉生产的1 80t 26Cr2Ni4MoV钢锭
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条