1) morphology of coke deposits
积碳形貌
2) carbide morphology
碳化物形貌
1.
The effect of RE and heat treatment on eutectic carbide morphology and impact toughness of white cast iron was studied.
研究了稀土变质与热处理对白口铸铁的共晶碳化物形貌及冲击韧度的影响。
2.
The effects of improving white cast iron carbide morphology on the amount of modificator,solidification speed carbide equivalent,the time and temperature of modification such as other technological factor.
对白口铸铁采用稀土复合变质处理工艺进行了研究 ,试验了变质剂的加入量、凝固速度、碳当量、变质温度及时间等工艺因素对改善普通白口铸铁碳化物形貌的影响。
3) carbon formation,formation of carbon
积碳的形成
4) appearance
[英][ə'pɪərəns] [美][ə'pɪrəns]
形貌
1.
Effects of electromagnetical field on puerarin crystallization velocity,crystal appearance and purity;
电磁诱导对葛根素结晶速率、晶体形貌及纯度影响研究
2.
Through such ultra-fining-pretreatment of 40Cr and T10A steels as salt-bath cyclic quenching, high frequency hardening and laser hardening, the microstructure appearance, the superplastic microstructure characteristic and their forming characteristic of isothermal superplastic welded joint of heterogeneous steels are systematically studied by the metallurgical microscope and electron microscope.
通过对40Cr/T10A钢试样及试样待焊面表层分别实施盐浴加热循环淬火、高频淬火及激光淬火的组织超细化预处理,借助于金相及电子显微分析技术,系统研究了异种钢恒温超塑焊接头区显微组织形貌、超塑性微观结构特征及其形成特点,提出了恒温超塑焊接头组织特征区域的构成模型。
3.
The appearance and polarized light property of modified starch of different source and different modified mode were studied by polarizing microscope.
用偏光显微镜研究不同来源和不同变性方式的变性淀粉的形貌和偏光特性。
5) morphologies
形貌
1.
Preparation of nano Zn(Ⅱ)-phtalate with different morphologies;
不同形貌的纳米邻苯二甲酸锌盐制备的研究
2.
Synthesizing and Characterizing Various Morphologies of α-K_7P_2W_(17)NbO_(62)
不同形貌的α-K_7P_2W_(17)NbO_(62)的制备与表征
3.
And the morphologies of lead tungstate crystal were different when different surfactants of polygycol 200 and cetyltrimethyl ammonium bromide(CTAB) were added in the experiments.
讨论了表面活性剂对钨酸铅低维粉体形貌的影响,认为PEG200对分散性良好的钨酸铅纳米晶的生成起了关键作用,而CTAB则促进了成形良好的菱形钨酸铅微晶的生成。
6) topography
[英][tə'pɔɡrəfi] [美][tə'pɑgrəfɪ]
形貌
1.
Topography of Polyhydroxybutyrate Banded Spherulites;
聚羟基丁酸酯环带球晶的形貌研究
2.
Conditions for topography and diameter analysis of SiO_2 micro-ball by scanning electron microscope;
二氧化硅微球的扫描电镜测长及形貌观察条件
3.
After these precursors analyzed by TG-DTA, and decomposed at 610℃, the phase and topography of the thermolysis products were characterized by XRD, SEM.
用XRD、SEM对热分解产物进行表征,获得了多种不同微观形貌的NiCo2O4复合氧化物。
补充资料：重油积碳清洗剂
重油积碳清洗剂由溶剂、助溶剂、渗透剂、剥离剂等复配而成的清洗剂，除有效清除各类油污外，对各类碳化污垢具有显著作用是应用渗透剥离的原理，快速使碳性物从金属表面呈片状剥落，同时又不会腐蚀、损伤母体和金属零件的精度来达到清洗的完美效果。除一般积碳的时间为30分钟左右。绝对强力快速！。可用于清除发动机内壁、压缩机、喷油嘴、油换热器、螺杆等零件上的积炭以及积碳与油污的共聚物。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条