1) turn-on temperature
开机温度
2) engine coolant temperature switch
发动机冷却液温度开关
3) transmission oil temperature switch
变速箱机油温度开关
4) switch temperature
开关温度
1.
Three types of thermal sensitive polyurethane TSPU(a)、TSPU(b)and TSPU(c),were synthesized and their phase transition temperature of the soft segment(defined as switch temperature,Ts) were measured.
合成了三种温敏聚氨酯TSPU(a)、TSPU(b)和TSPU(c),并对其软段相的转变温度(即开关温度)进行了表征,同时研究了不同种类聚氨酯的相容性对共混体系开关温度阀值的影响。
5) initial rolling temperature
开轧温度
1.
The rolling results and performance analysis showed that the initial rolling temperature should be controlled from 1 100 ℃ to 1 180 ℃, If the temperature is higher than 1180 ℃, the rolled piece will be difficult to be bitted;if the temperature is below 1 100 ℃, the steel tend to thermal crisp and the head of rolled piece is easy to crack.
轧制结果及性能分析表明,开轧温度控制在1100～1180℃范围内较好,高于此温度范围轧制时会出现轧件打滑,咬入困难现象,温度低于此范围,钢容易发生热脆,轧件头部易开裂。
6) Mould-opening Temperature
开模温度
补充资料：铂电阻温度表(见电阻温度表)
铂电阻温度表(见电阻温度表)
表。bod旧nZu wendubiao铂电阻温度表见电阻温
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条